Martin Exterior Projection Pro Compact handleiding

Niet gecategoriseerd

Martin

71 pagina's

PDF beschikbaar

Handleiding

12 Martin

Exterior Projection Pro Compact User Manual, Rev. A

Hibernation mode

Available using RDM, Martin Companion and the Control / Settings DMX channel

Activating Hibernation mode puts fixtures into a standby state where power remains applied but at a

significantly reduced level.

Drying out function

Available using RDM, Martin Companion and the Control / Settings DMX channel

If you need to eliminate humidity from inside the fixture, use the drying out procedure as follows.

1. Carry out this procedure during dry conditions only. The fixture must be connected to power.

2. Open the effects compartment cover as described later in this User Manual.

3. Activate the Drying out function. The fixture LEDs will light up, the heating plate will activate, the

LED cooling fan will shut down and the three internal cooling fans will operate at full speed. Drying

out will continue until you turn it off using Martin Companion, RDM or the Control / Settings DMX

channel.

4. De-activate the Drying out function (on the Control / Settings DMX channel, send DMX value 210

for one second to stop the function).

5. Install a new anti-humidity sachet in the effects compartment cover and re-install the cover as

described later in this User Manual.

Offline mode

Available using RDM and Martin Companion

You can select from four options to decide how the fixture should behave when it is powered on but

not receiving a control signal:

• BLACK OUT (default setting): Fixture blacks out if it is not receiving a control signal.

• FULL OUTPUT: Fixture goes to 100% intensity white output, gobo slot 1, if it is not receiving a

control signal.

• STANDALONE: Fixture executes a stand-alone show. See ‘Synchronized operation’ and

‘Standalone programming’ below.

• LAST DMX STATE: Fixture stores its last DMX ‘scene’ in internal memory and displays this scene

when powered on and not receiving a control signal. If the fixture has never received a DMX signal,

it uses the default DMX values for each channel.

Synchronized operation

Available using Martin Companion

You can select from three options that define fixture behavior when the fixture is set to STANDALONE

and is not receiving a DMX control signal:

• NORMAL OPERATION: The fixture executes its own programmed stand-alone show and does not

send or respond to synchronizing signals.

• SYNC HOST: The fixture executes its own programmed stand-alone show and sends a

synchronizing signal to the other fixtures on the DMX link at each time it changes to the next scene

in its show. All the fixtures on the DMX link that are set to SYNC CLIENT will change to the next

scene in their programmed standalone shows when they receive this synchronizing signal.

• SYNC CLIENT: The fixture executes its programmed stand-alone show, changing scenes in

response to synchronizing signals from the HOST fixture.

The synchronized operation setting (NORMAL OPERATION, SYNC HOST or SYNC CLIENT) is only

relevant when Offline Mode is set to STANDALONE.

Bekijk gratis de handleiding van Martin Exterior Projection Pro Compact, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.