Martin Exterior PixLine 20 handleiding
Handleiding
Je bekijkt pagina 29 van 44
Service and maintenance 29
Service and maintenance
Warning! Read “Safety information” on page 5 and “Precautions to avoid damage” on page 10
before carrying out service on the Exterior PixLine.
Warning! Lock out AC mains power to the installation before servicing.
Warning! Refer any service operation not described in this manual to a qualified service technician.
Important! Excessive dirt buildup causes overheating and may damage the product. Damage
caused by inadequate cleaning is not covered by the product warranty.
The user will need to clean the Exterior PixLine periodically. All other service operations on the Exterior
PixLine must be carried out by Martin Professional or its approved service agents.
Installation, on-site service and maintenance can be provided worldwide by the Martin Professional Global
Service organization and its approved agents, giving owners access to Martin’s expertise and product
knowledge in a partnership that will ensure the highest level of performance throughout the product’s
lifetime. Please contact your Martin® supplier for details.
Cleaning
Cleaning schedules vary depending on the operating environment. It is therefore impossible to specify
precise cleaning intervals for the Exterior PixLine. Environmental factors that may result in a need for
frequent cleaning include airborne dust and pollution.
Inspect products frequently to see whether cleaning is necessary. If in doubt, consult your Martin® dealer
about a suitable maintenance schedule.
To clean the product, use warm water and a soft brush or a low-pressure or medium-pressure water jet. Use
car shampoo to help remove dirt and grease. If possible, dry with a soft cloth to avoid streaking. Do not use
a stiff brush or scouring pad. Do not use solvents or abrasives.
Condensation
Under certain conditions, condensation can become visible under diffusers or lenses on the front of fixtures.
This is normal and harmless.
Vents provided in the ends of fixtures expel water vapor. Condensation is gradually expelled through the
vents as fixtures go through power off/on cycles, cooling down and then warming up. Ensure that there is
airflow to and from the vents: keep them free of dirt and debris.
LED performance
At Martin® we use the best components available, but the characteristics of all LEDs change gradually over
many thousands of hours of use. Not all colors change at the same rate, and rates of change vary
depending on factors such as temperature and how intensively a particular color is used. Because of the
changes, overall light output and the exact hues obtained from specific color mixes in all LED-based
products can be expected to shift slightly over time.
To help you obtain consistent output despite these changes, Martin® P3 software from version 4.1.0
contains the P3 Fixture Adjuster tool. This feature lets you compensate for changes in LED characteristics
and restore initial output and color authenticity levels. Please contact Martin® for more details.
Bekijk gratis de handleiding van Martin Exterior PixLine 20, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Martin |
| Model | Exterior PixLine 20 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5166 MB |
