Martin Exterior Dot Pro handleiding
Handleiding
Je bekijkt pagina 14 van 60
14 Martin
®
Exterior Dot-Pro HP User Manual Rev. A
Color modes
The Exterior Dot-HP Pro has four color modes: Direct, Extended Gamut, Calibrated Color and Linear
Video.
When a Dot is set to Direct DMX control mode, it is fixed in Direct Color Mode – you cannot select a
calibrated color mode.
When a Dot is set to Standard, Extended, RGB or Pixelmap DMX control mode, you can select from
three color modes via RDM:
• Extended Gamut (default setting) – The White point and mixed colors are calibrated, but you can
saturate colors to the maximum level available. No brightness calibration is used, so you may observe
minor brightness differences between individual Dots.
• Calibrated Color – The entire color gamut is calibrated, resulting in a slight loss of color saturation.
Additionally, the brightness of each Dot is calibrated for best consistency.
• Linear Video – The entire color gamut is calibrated, resulting in a slight loss of color saturation.
Additionally, the brightness of each Dot is calibrated and adjusted so that the product behaves like a
video screen.
CTC
The MANUAL_CTC_VALUE command lets you set a default color temperature for Dots when
controlling them in a DMX Mode that does not offer CTC.
Tint
The MANUAL_TINT_VALUE command lets you adjust the tint of Dots.
Utilities
The Exterior Dot-HP Pro offers various functions to help you manage Dots:
• If you apply an IDENTIFY_DEVICE command to a Dot, it will flash a signal to let you know which Dot
you are communicating with. This can be useful when setting up Dots in a large installation.
• RESET_DEVICE – Carries out a full reset of the Dot’s electronics.
• SELF_TEST_DESCRIPTION – Lets you select from various sequences that test the Dot’s functionality
and LEDs.
• PERFORM_SELFTEST – Runs a test sequence.
• FACTORY_DEFAULTS – Deletes any custom settings that have been configured via RDM and returns
a Dot to its factory default settings.
Supported parameters
Exterior Dot-HP Pro Dots can communicate the control parameters that they support to the RDM
controller and give brief information on each parameter.
Fixture information
The Exterior Dot-HP Pro can communicate the following information to the RDM controller:
• Basic fixture information – type of fixture.
• Name of product and manufacturer.
• Device label – This information can be edited by the user, providing a means of giving an individual Dot
its own ID number, for example.
• Currently installed firmware version.
• Number of hours Dot has had power applied since manufacture (non-resettable).
• Number of hours LEDs have been active since manufacture (non-resettable).
• Number of on/off power cycles since manufacture (non-resettable).
• Serial number – This is a factory-set serial number that cannot be changed.
Bekijk gratis de handleiding van Martin Exterior Dot Pro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Martin |
| Model | Exterior Dot Pro |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9000 MB |
