Martin Exterior Dot Pro handleiding
Handleiding
Je bekijkt pagina 13 van 60
Martin
®
Exterior Dot-Pro HP User Manual Rev. A 13
Dimming curves
Four dimming curves are available via RDM using the DIMMER_CURVE PID:
• Optically linear – The increase in light intensity appears to be linear as DMX value is increased.
• Square law (default setting) – light intensity control is finer at low levels and coarser at high levels.
• Inverse square law – Light intensity control is coarser at low levels and finer at high levels.
• S-Curve – light intensity control is finer at low levels and high levels and coarser at medium levels.
Behavior when no DMX signal is present
The OFFLINE_MODE command lets you define how Dots behave if power is applied but Dots are not
receiving a DMX signal (or if Dots are powered on and being controlled by DMX, and then the DMX
signal stops).
Four options are available:
• Blackout (default setting) – Intensity set to zero light output when no DMX signal is present.
• Standalone – Dot switches to standalone operation when no DMX signal is present. If you have
programmed a scene or scenes using Martin Companion as described later in this User Manual, the
Dots will display that scene when no DMX signal is present.
• Hold Last State – Dots follow the last DMX values received.
• Full Output – All LEDs go to 100% intensity when no DMX signal is present.
Power limit mode
The POWER_LIMIT_MODE command lets you set Dots to full or half power via RDM.
You can also set Dots to full or half power by moving a physical switch inside Martin P3 PowerPort
500 IP, P3 PowerPort 2000 IP and Exterior AC-Feeder devices as well as by adjusting Dot settings in
Martin P3 System Controllers.
Setting Dots to half power can be useful for night-time or TV studio applications, for example, where
full power is not needed or may be undesirable. The HALF setting also lets you connect a higher
number of Dots, meaning that an installation will require fewer system components.
LED refresh modes
You can set the Exterior Dot-HP Pro to one of two refresh rates via RDM or P3:
• Standard refresh mode (default): 1001 Hz
• High refresh mode (for which the RDM PID is LOW_NOISE_MODE): 4004 Hz.
In High refresh mode, dimming is in 14-bit resolution. In Standard refresh mode, dimming is in 16-bit
resolution.
For camera applications, we recommend using High refresh mode.
Bekijk gratis de handleiding van Martin Exterior Dot Pro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Martin |
| Model | Exterior Dot Pro |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9000 MB |
