Martin Exterior AC-Feeder handleiding
Handleiding
Je bekijkt pagina 5 van 17
Martin
®
Exterior AC-Feeder and Exterior DC-Feeder Safety, Installation and User Manual 5
Protection from electric shock
Ensure that Exterior AC-Feeder and Exterior DC-Feeder devices are electrically connected
to ground (earth).
Use only a source of mains power that complies with local building and electrical codes and
has both overload and ground-fault (earth-fault) protection.
Do not attempt to open an Exterior DC-Feeder. There are no user-serviceable parts inside it.
Provide a means of locking out AC mains power so that power to the installation can be shut
down and made impossible to reapply, even accidentally, during work on the installation.
Isolate the product from power immediately if the power plug or any seal, cover, cable, or
other component is damaged, defective, deformed or showing signs of overheating. Do not
reapply power until repairs have been completed.
Do not expose connectors or cable glands to stresses caused by lengths of cable hanging
from them or by tight cable bends. Support the weight of cables running to and from
products.
Keep the supplied plugs installed in all unused cable glands to protect from humidity.
The Exterior AC-Feeder and Exterior DC-Feeder are IP66-rated and may be used in
permanent indoor and outdoor installations. Do not expose these products to high-pressure
water jets from any direction.
When installing cable, create a ‘drip loop’ (see illustration
on right) so that the cable arrives at cable glands or
connectors from below.
Do not allow water to pool around the Exterior AC-Feeder’s
pressure equalization valve. Make a visual check of the
pressure equalization valve periodically. If a valve appears
to be dirty it may be blocked. Consult your Martin supplier
for replacement.
Before using a device, check that all power distribution
equipment and cables are in perfect condition and rated for
the electrical requirements of all connected devices.
Disconnect products from AC mains power and ensure that power cannot be reconnected
before carrying out any installation or maintenance work and when the product is not in use.
Do not connect products to mains power in a daisy chain that will exceed the electrical
ratings of any device, cable or connector in the chain.
Check and respect the directions given in the user manuals of all the devices that you intend
to connect to an Exterior AC-Feeder or Exterior DC-Feeder. Pay particular attention to the
instructions and warnings that apply to:
• system layout,
• connections to other devices,
• specified cables,
• maximum cable lengths, and
• maximum number of devices that can be connected.
The external diameter of the cables used to connect Exterior AC-Feeder devices to power
and data must be suitable for the cable glands provided, or water can enter the product and
create a safety hazard or cause damage. The cables must have the following external
diameter:
• AC mains power in: 8-13 mm (0.32-0.51 in.)
• Network data in: 5-8 mm (0.2-0.32 in.)
Drip loop
Bekijk gratis de handleiding van Martin Exterior AC-Feeder, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Martin |
| Model | Exterior AC-Feeder |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3344 MB |
