Makita TW003G handleiding
Handleiding
Je bekijkt pagina 9 van 88
9 ENGLISH
approximately10secondsafterreleasingtheswitch
trigger.
With the lamp status OFF, the lamp does not turn on
even if pulling the trigger.
►Fig.4: 1. Lamp
►Fig.5: 1. Button
NOTE:Toconrmthelampstatus,pullthetrigger.
Whenthelamplightsupbypullingtheswitchtrigger,
the lamp status is ON. When the lamp does not come
on, the lamp status is OFF.
NOTE:Whenthetoolisoverheated,thelightashes
foroneminute,andthentheLEDdisplaygoeso.In
this case, cool down the tool before operating again.
NOTE:Useadryclothtowipethedirtothelens
of the lamp. Be careful not to scratch the lens of the
lamp,oritmaylowertheillumination.
NOTE: While pulling the switch trigger, the lamp
status cannot be changed.
NOTE:Forapproximately10secondsafterreleasing
the switch trigger, the lamp status can be changed.
Reversing switch action
CAUTION: Always check the direction of
rotation before operation.
CAUTION: Use the reversing switch only after
the tool comes to a complete stop. Changing the
directionofrotationbeforethetoolstopsmaydam-
age the tool.
CAUTION: When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
►Fig.6: 1. Reversing switch lever
Changing the operation mode
This tool has multiple operation modes: 4 steps of impact mode and 3 steps of auto-stop mode. Select an appropri-
atemodeaccordingtoyourwork.
Youcanchangetheoperationmodewithinapproximatelyoneminuteafterreleasingtheswitchtrigger.
NOTE:Youcanextendthetimetochangetheoperationmodeapproximatelyoneminuteifyoupressthebut-
ton or .
Changing the impact mode
You can change the impact force in four steps: 4 (max), 3 (hard), 2 (medium), and 1 (soft).
Theleveloftheimpactforcechangeseverytimeyoupressthebutton .
►Fig.7
Operation mode
(Impact force grade displayed
on panel)
Maximum blows (min
-1
(/min)) Purpose
TW001G TW002G TW003G
4 (Max)
2,500 2,400 2,400 Tightening when the force and the
speed are desired.
3 (Hard)
2,400 2,000 2,300 Tightening with less force and
speed than Max mode (easier to
control than Max mode).
2 (Medium)
2,200 1,800 2,000 Tightening with less force to avoid
screw thread breakage.
1 (Soft)
1,900 1,700 1,600 Tighteningwhenyouneedne
adjustmentwithsmalldiameter
bolts.
: The lamp is on.
Bekijk gratis de handleiding van Makita TW003G, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Makita |
| Model | TW003G |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13299 MB |
