Mafell KSS 80 handleiding

Handleiding

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139140141142143144145146147148149150151152153154155156157158159160161162163164165166167168169170171172173174175176177178179180181182183184185186187188189190191192193194195196197198/ 198

Afdrukken

Je bekijkt pagina 31 van 198

-31-

9 Troubleshooting

Danger

Determining the causes for existing defects and eliminating these always requires

increased attention and caution. Pull the mains plug beforehand!

Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,

please contact your dealer or the MAFELL customer service directly.

Defect

Cause

Elimination

Machine cannot be switched on

and the speed adjusting wheel

lights up red

Overtemperature shutdown

Allow the machine to cool down

Overvoltage switch-off

Have power supply checked by

an electrician

Undervoltage switch-off

Machine cannot be switched on

and the speed adjusting wheel

does not light up

No mains voltage

Have power supply checked by

an electrician

Mains fuse defective

Have fuse replaced by an

electrician

Machine cannot be switched on

and the speed adjusting wheel

lights up green

Carbon brushes worn

Take the machine to a MAFELL

customer service shop

Machine stops during cutting and

the speed adjusting wheel lights

up red

Overload switch-off

Reduce feed speed

Overvoltage switch-off

Have power supply checked by

an electrician

Undervoltage switch-off

Machine stops during cutting and

the speed adjusting wheel does

not light up

Mains failure

Have mains-side pre-fuses

checked by an electrician

Saw blade jams as the machine

is advanced

Feed rate too fast

Reduce feed speed

Blunt saw blade

Release the switch immediately.

Remove the machine from the

workpiece and replace the saw

blade

Tension in the workpiece

Heightened caution during

sawing, risk of backlash

increases.

Poor machine guidance (for

example due to free-hand

guidance)

Use parallel guide fence

Uneven workpiece surface

Straighten the surface

Saw blade vibrates in the work

piece

Saw blade not correctly adjusted Retighten saw blade

Work piece not fastened Fasten work piece with clamps

Saw blade stops - motor

continues to turn

Saw blade not correctly fastened

Retighten saw blade

Burn marks on the cut surfaces

The saw blade used is

unsuitable for the task or blunt

Replace saw blade

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139140141142143144145146147148149150151152153154155156157158159160161162163164165166167168169170171172173174175176177178179180181182183184185186187188189190191192193194195196197198/ 198

Bekijk gratis de handleiding van Mafell KSS 80, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd