Mackie MainStream handleiding
Handleiding
Je bekijkt pagina 31 van 64
MACKIE MATRIX LIVE STREAMING MIXER SOFTWARE
3
Parameter Setup – Compressor (Easy)
Compressors are used to reduce or limit transient peaks in a signal. If the signal is too hot, turn down that channel’s gain,
otherwise leave it alone. As the input level to the compressor increases, the output level increases linearly until the threshold
point is reached. Afer that point, the output level no longer increases linearly. Instead, it increases at a reduced rate determined
by the ratio setting.
The attack and release controls aect the rate of the gain change; attack aects the rate of the onset of gain reduction
and release aects the recovery rate once the transient has passed.
Attack — Attack determines how quickly the compressor reacts once the signal is above threshold.
Short attack times allow compressing on short transients, while longer attack times cause these transients to be ignored.
The range of the attack time varies from 0 ms to 50 ms.
Ratio — Ratio sets the amount of gain reduction applied as the signal exceeds the threshold level.
The range of the ratio of the compressor varies from : to 0:.
Release — Release determines how long it takes for the compressor to end gain reduction once the signal drops
back below the threshold. The range of the release speed varies from 0 ms to 500 ms.
Threshold — Threshold sets the threshold of the compressor in dB below 0 dBFS.
The range of the threshold setting varies from –60 dB to 0 dB.
Like the EQ and gate tabs, simply mouse click in one of the min/max boxes and enter the minimum and maximum settings
preferred. Continue to do so for each parameter. On the far lef-hand side are several small gray boxes. Comp parameters
that you would like added to the final mix need to be engaged, as well. To do so, mouse click on the box to give it a green
check mark. We prefer full comp and checked all four boxes (as well as added some min/max settings), see below:
The last thing to do here is to click on “Apply” in the lower-right corner of the screen so the settings are saved and, well...
applied! Or click on “Discard changes” in the lower-lef corner of the screen to exit and return to the main Control Mode screen.
Parameter Low Value High Value
Attack 0 ms 50 ms
Ratio : 0 :
Release 0 ms 500 ms
Threshold –60 dB 0 dB
Bekijk gratis de handleiding van Mackie MainStream, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Mackie |
| Model | MainStream |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10845 MB |