Lofrans XP800 handleiding
Handleiding
Je bekijkt pagina 9 van 18
9
www.lofrans.com
Do not carry out the anchor recovery operation by relying only on the onboard batteries. Start the motor of the boat
(or the generator) to obtain the necessary electromotive force.
The circuit breaker does not protect against an excessive increase in the motor temperature due to a prolonged operation of
the anchor windlass. Therefore, give the motor the necessary time to cool, to avoid possible damages to the motor thereafter
(5 min Duty Cycle).
5.2 Weighing the anchor
1. Make sure that the circuit breaker is activated.
2. Make sure that the clutch is well tightened. Take out the handle from the gipsy.
3. Disengage the chain stopper and safety stops.
4. Press the UP button from the control at your disposal until the anchor reaches its position inside the bow roller.
5. Deactivate the circuit breaker.
6. Fix the chain with the chain stopper. In this way a potential damage of the anchor windlass will be avoided as well as unexpected
chain releases.
To safeguard the anchor windlass, the circuit breaker is sized so that it comes into action when the anchor windlass is subjected to higher
loads than those for which it has been designed. Should it get released owing to an overload reactivate it again and wait some minutes
before operating it; waiting for the operation after an overload is necessary to allow the circuits to cool and recover their functionalities.
UP
UK
5.3 Notes for use
1. By paying out the chain, it is necessary to maneuver so that the chain is laid down on the seabed without heaping on itself.
2. To ease the recovery and not overloading the windlass, steer up in a way that the boat slowly moves on the vertical of the anchor.
3. When the anchor is in the vicinity of the bow roller, slow down the recovery to check at best the insertion of the anchor into the seat.
During mooring, the load on the chain can be very high due to current, wind and waves.
Mooring, do not use the anchor windlass as strong point but always use a chain stopper.
If during recovery, the anchor windlass should block, slip or turn into self-protection mode, check the cause before continuing.
DOWN
UP
LOFRANS'
Bekijk gratis de handleiding van Lofrans XP800, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | XP800 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2438 MB |
