Lofrans SX7 handleiding
Handleiding
Je bekijkt pagina 5 van 22
5
www.lofrans.com
UK
3.5 Prevention from electrolysis
For hulls that conduct electricity, it is essential that the anchor windlass be insulated from the deck through a non-conductive gasket (not
supplied). In addition, it is important that also the anchor and the chain be insulated from the hull, including
3.6 Deck thickness
The area of the deck where the capstan is mounted must be solid and resistant so to be able to
support the stresses due to the recovery of the anchor.
The standard series studs and shaft allow an admissible range of deck thickness of 100 -135 mm.
Upon request, different deck thicknesses may be provided.
3.7 Deck installation
3.8 Under deck installation
1. Place carefully the drilling template on the deck,
by ensuring the correct alignment with the bow.
1. Grease the main shaft.
2. Join the reducer to the upper part by
aligning the motor far from the chain hole.
3. Screw washers and related nuts to
the studs by fastening them appropriately.
4. Connect the cables coming from the battery
to the electric motor by following the indications
of the wiring diagram
2. Mark and drill as indicated in the Mark and drill
as indicated in the gure. Let the edges of the
holes sharp, while the edge side of the holes of
the chain towards the bow must be smoothed for
an angle of 45° degree gure. Let the edges of the
holes sharp, while the edge side of the holes of the
chain towards the bow must be smoothed for an
angle of 45° degree.
Note:
It is recommended to seal the base of the anchor windlass to
the deck by means of silicone glue. Do not use a permanent
glue to x the base of the anchor windlass to the deck since
this will make difcult the removal in case of maintenance
or intervention.
3. Place carefully the upper part of the anchor windlass on
the deck.
2
3
1
Without these precautions, the electrolysis phenomenon will lead to a rapid
corrosion of the anchor windlass.
Chain pipe installation is suggested in order to
guide the chain properly aligned to the chain locker
and keep windlass efciency high*
Deck thickness:
100 - 135mm
Lofrans'
Bekijk gratis de handleiding van Lofrans SX7, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | SX7 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3143 MB |
