Lofrans SX7 handleiding
Handleiding
Je bekijkt pagina 12 van 22
12
SX7
Problem Possible causes Solution
1. The anchor windlass
does not work when a
control is operated
1.1 Protection switch in OFF position
1.2 Lack of voltage in the system
1.3 Failure of the control box
1.4 Failure of the control
1.5 Failure of the electric motor
1.1 Check the protection switch and set it in the
ON position
1.2 Check the charge status of the battery, check connections
1.3 Check and possibly replace the control box
1.4 Check and possibly replace the control
1.5 Measure the electric motor voltage; if it is OK, check the
brushes and clean them. If it does not work, replace the electric
motor
2. The chain jams
frequently
2.1 The chain locker is not deep
enough with respect to the quantity of
chain chosen
2.2 The chain is not suitable for the
gipsy
2.3 The chain is not calibrated
2.1 Position the anchor windlass in the deepest point of the
chain locker or reduce the quantity of chain
2.2 Change the gipsy
2.3 Check the chain: if it does not meet the tolerances, it must
be replaced
3. The anchor windlass
turns slowly
3.1 Unsuitable cable sections
3.2 Deck oors not parallel
3.3 Bad electrical connections
3.4 Dirty brushes
3.5 Water inltrations in the electric
motor
3.1 Increase cable section
3.2 Make oors parallel by interposing thicknesses
3.3 Check connections
3.4 Clean brushes
3.5 Replace the electric motor
4. The electric engine
runs but the shaft does
not rotate either Up or
Down
4.1 Heavy wear or breakage of teeth
of the crown / worm screw.
4.2 Breakage of the engine spindle.
4.1 (SERVICE) Uninstall the winch and replace the broken
parts. Check out carefully that pieces or splinters of broken
parts did not enter into the oil circuit and have ruined other
mechanical parts. (*)
4.2 (SERVICE) Replacing of the engine. Care must be taken
that the broken part did not remain in the hole of the worm
screw. (*)
(*) Take advantage of this opportunity to replace any other worn
parts, especially gaskets, screws, tabs, seeger, and oil.
1. By turning anticlockwise, remove the hand-wheel of the gypsy
through the manoeuvre handle.
2. Slip off from the shaft the upper clutch cone, the gipsy, and the
lower clutch cone.
3. Wash with running water. DO NOT USE WATER UNDER
PRESSURE.
4. Check that there is no evidence of corrosion or mechanical
stresses.
5. Reassemble by proceeding in the reverse order, remembering
to lubricate threads and all moving parts with yellow grease (non
conductive).
7 TROUBLESHOOTING
6.2 Gipsy maintenance/replacement
Lofrans'
Bekijk gratis de handleiding van Lofrans SX7, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | SX7 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3143 MB |
