Lofrans SX7 handleiding
Handleiding
Je bekijkt pagina 11 van 22
11
www.lofrans.com
DOWN
UP
5.4 Notes for use
During mooring, the load on the chain can be very high due to current, wind and waves.
During mooring, do not use the anchor windlass as strong point but always use a chain stopper.
If during recovery, the anchor windlass should block, slip or turn into self-protection mode, check the cause before proceeding.
Follow strictly the maintenance programme. Not meeting the maintenance programme will cause forfeiture of the warranty.
1. By paying out the chain, it is necessary to manoeuvre so that the chain is laid down on the seabed without heaping on itself.
2. To ease the recovery and not overloading the capstan, steer up in a way that the boat slowly moves on the vertical of the anchor.
3. When the anchor is in the vicinity of the bow roller, slow down the recovery to check at best the insertion of the anchor into the seat.
A. Clean all external surfaces and hidden points with fresh water and soft cloth or non abrasive sponge to remove all salt layers. Do
not use chlorine, bleach or acid solutions to clean the windlass as this will damage the INOX parts and the seals. Apply metal polish
compound and coat all INOX parts to remove oxidation and renew the bright nish of the material.
B. Grease the rotating parts with yellow marine grease that is non conductive. Particularly, the main shaft threads and clutch cones. Check
for evidences of corrosion and mechanical stresses. Apply anti seize grease to the clutch nut and main shaft thread (635494+636441)
C. Check the terminals of the electric motor. Test the voltage drop at the terminals.
D. Replace all gaskets.
E. Remove the anchor windlass from the deck to clean the salt under the base and seal again.
6 MAINTENANCE
USE OF THE YACHT (MONTHS)
LESS THAN 2 FROM 2 UP TO 6 MORE THAN 6 CHARTER
EVERY 3 MONTHS A - A A - B A - A
EVERY 6 MONTHS A - B
EVERY 12 MONTHS A - B - C C C C - D
EVERY 24 MONTHS D D E
EVERY 36 MONTHS D - E E E
Disconnect all electrical power to the anchor windlass before any maintenance and when the windlass is not used for
long period of time.
6.1 Maintenance programme
For obtaining the best performances and the utmost efciency of the anchor windlass, it is necessary to follow strictly the maintenance
programme indicated hereby.
UK
Lofrans'
Bekijk gratis de handleiding van Lofrans SX7, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | SX7 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3143 MB |
