Lofrans SX4 handleiding
Handleiding
Je bekijkt pagina 12 van 22
12
SX4
Problem Possible causes Solution
2. The chain jams
frequently
2.1 The chain locker is not deep
enough with respect to the quanti-
ty of chain chosen
2.2 The chain is not suitable for the
gipsy
2.3 The chain is not calibrated
2.1 Position the anchor windlass in the deepest point of the
chain locker or reduce the quantity of chain
2.2 Change the gipsy
2.3 Check the chain: if it does not meet the tolerances, it must
be replaced
3. The anchor windlass
turns slowly
3.1 Unsuitable cable sections
3.2 Deck oors not parallel
3.3 Bad electrical connections
3.4 Dirty brushes
3.5 Water inltrations in the electric
motor
3.1 Increase cable section
3.2 Make oors parallel by interposing thicknesses
3.3 Check connections
3.4 Clean brushes
3.5 Replace the electric motor
4. The electric engine
runs but the shaft
does not rotate
either Up or Down
4.1 Heavy wear or breakage of teeth
of the crown / worm screw.
4.2 Breakage of the engine spindle.
4.1 (SERVICE) Uninstall the winch and replace the broken
parts. Check out carefully that pieces or splinters of broken
parts did not enter into the oil circuit and have ruined other
mechanical parts. (*)
4.2 (SERVICE) Replacing of the engine. Care must be taken
that the broken part did not remain in the hole of the worm
screw. (*)
(*) Take advantage of this opportunity to replace any other worn
parts, especially gaskets, screws, tabs, seeger, and oil.
Lofrans'
Bekijk gratis de handleiding van Lofrans SX4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | SX4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3008 MB |
