Lofrans SX3 handleiding
Handleiding
Je bekijkt pagina 13 van 22
13
www.lofrans.com
Problem Possible causes Solution
5. The electric engine
runs, the shaft
rotates Up, but does
not rotate Down
5.1 The chain locker is tangled;
therefore, the emergency
mechanism becomes operative.
5.2 The chain is of poor quality with
burrs and zinc deposits that do
not allow the free ow of the
links; therefore, the emergency
mechanism becomes operative.
5.3 The chain was placed in the locker
in block and the links are stuck
with each other; therefore, the
emergency mechanism becomes
operative.
5.4 Wear of the emergency
mechanism of the spring control.
5.5 The chain stripper interferes with
the gypsy: it is possible to weigh
the operation, while to lower, the
emergency mechanism becomes
operative.
5.1 Check out that immediately after the anchor there is a joint
that allows the chain to unfold properly when weighed.
5.2 Remove the chain from the locker and inspect it link by link.
Intervene with the appropriate tools to make it as loose as
possible and free of obstructions.
5.3 Lower manually all the chain in a sea bed deep enough to
enable it to unfold properly. Retrieve it with the winch.
5.4 A (SERVICE) Uninstall the winch from the boat and
disassemble it into its parts by replacing the spring. Take
advantage of this opportunity to replace any other worn
parts, gaskets, screws, tabs, seeger, and oil.
B (SERVICE) It is possible to block the EMERGENCY
MECHANISM so that the gears are always engaged
both in UP and in Down. This operation must be
authorized by the shipowner. The solution rules out
completely the possibility of carrying out the
emergency operation.
5.5 Restore the condition of the chain stripper by repositioning
properly in the gypsy centreline. If it is deformed. It must be
replaced.
6. The electric engine
runs but it cannot be
bell warped.
6.1 The bell warp is being used
wrongly; therefore, the emergency
mechanism becomes operative
6.1 To carry out the warping operation the main shaft must run
in the same rotation direction of the winch gypsy when it
weighs the chain.
7. The winch cannot be
weighed: the electric
engine runs, the
shaft runs, but the
gypsy is still
7.1 The gypsy is not closed on the
clutch cones and slips under the
load effect, or for some reason
the closing wheel is at end stroke.
Check out all pieces in sequence.
7.2 The clutch cones or the gypsy
cones are deformed and the
clutch hubs are in contact and
prevent closure.
7.1 Check out clutch tightening. If necessary, measure the
parts and check out possible deformations. It is possible to
add some thickness to stem the problem. Then replace the
damaged parts.
7.2 Replace the clutch and/or the gypsy
UK
Lofrans'
Bekijk gratis de handleiding van Lofrans SX3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | SX3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3215 MB |
