Lofrans SX2 handleiding
Handleiding
Je bekijkt pagina 11 van 20
11
www.lofrans.com
A. Clean all external surfaces and hidden points with fresh water and soft cloth or non abrasive sponge to remove all salt layers. Do
not use chlorine, bleach or acid solutions to clean the windlass as this will damage the INOX parts and the seals. Apply metal polish
compound and coat all INOX parts to remove oxidation and renew the bright nish of the material.
B. Grease the rotating parts with yellow marine grease that is non conductive. Particularly, the main shaft threads and clutch cones. Check
for evidences of corrosion and mechanical stresses. Apply anti seize grease to the clutch nut and main shaft thread (635490+630661)
C. Check the terminals of the electric motor. Test the voltage drop at the terminals.
D. Replace all gaskets.
E. Remove the anchor windlass from the deck to clean the salt under the base and seal again.
6.1 Maintenance programme
UK
1. By turning anticlockwise, remove the drum through the
manoeuvre handle.
2. Remove the 2 M8 screws from the side of the base that connect
the stripper and remove it.
3. Slip off from the shaft the upper clutch cone, the gipsy, and the
lower clutch cone.
4. Wash with running water. DO NOT USE WATER UNDER
PRESSURE.
5. Check that there is no evidence of corrosion or mechanical
stresses.
6. Reassemble by proceeding in the reverse order, remembering
to lubricate threads and all moving parts with grease.
6.2 Gipsy maintenance/replacement
Problem Possible causes Solution
1. The anchor
windlass does not
work when a control
is operated
1.1 Protection switch in OFF
position
1.2 Lack of voltage in the system
1.3 Failure of the control box
1.4 Failure of the control
1.5 Failure of the electric motor
1.1 Check the protection switch and set it in the ON position
1.2 Check the charge status of the battery, check connections
1.3 Check and possibly replace the control box
1.4 Check and possibly replace the control
1.5 Measure the electric motor voltage; if it is OK, check the brushes
and clean them. If it does not work, replace the electric motor
2. The chain jams
frequently
2.1 The chain locker is not deep
enough with respect to the
quantity of chain chosen
2.2 The chain is not suitable for
the gipsy
2.3 The chain is not calibrated
2.1 Position the anchor windlass in the deepest point of the chain
locker or reduce the quantity of chain
2.2 Change the gipsy
2.3 Check the chain: if it does not meet the tolerances, it must be
replaced
3. The anchor windlass
turns slowly
3.1 Unsuitable cable sections
3.2 Deck oors not parallel
3.3 Bad electrical connections
3.4 Dirty brushes
3.5 Water inltrations in the
electric motor
3.1 Increase cable section
3.2 Make oors parallel by interposing thicknesses
3.3 Check connections
3.4 Clean brushes
3.5 Replace the electric motor
7 TROUBLESHOOTING
Lofrans'
Bekijk gratis de handleiding van Lofrans SX2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | SX2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3068 MB |
