Livn Tower 700 Wi-Fi handleiding
Handleiding
Je bekijkt pagina 6 van 32
3.7 Factory mode
If you have any issue during the operation (including Wi-Fi connection), please try the factory mode
to reset your heater. Power on the heater, the temperature reading will display on the screen, press
and hold the “-” button for 5 seconds to reset the heater.
3.8
Control via
APP
3.8.1 Download the Livn APP
Scan the QR code to download the “Livn” APP or search “Livn” APP on
APP store or Google play store to start the procedure to download the
APP, open the APP and register with your phone number or Email
address.
3.8.2 Connect to Wi-Fi:
Step 1:
Turn on the power of the heater by pressing the Power Switch. The Wi-Fi signal
will start to flash rapidly. Open the APP on your smartphone and add your device. Choose
“Add Device”, then “Add Manually”, and then choose “Thermostat” to add the device.
Step 2:
Enter the Wi-Fi password of your home network. Please make sure your home Wi-Fi is
working and keep the heater and smartphone as close as possible to the Wi-Fi router.
Please notice that this heater only works with 2.4GHz Wi-Fi networks, it doesn’t support
5GHz networks currently. Also, make sure your internet router has enough capacity to
add a new device.
Step 3
: Wait till the connection status shows 100% to finish the settings and the Wi-Fi
signal on the control box will stop flashing.
If the heater failed to connect, please power off the heater and power it back on again
after a few seconds to try. If you still have any difficulty with the Wi-Fi connection, please
try the different Wi-Fi connection mode, please refer to “Wi-Fi reset” on point 3.9.
Bekijk gratis de handleiding van Livn Tower 700 Wi-Fi, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livn |
| Model | Tower 700 Wi-Fi |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5042 MB |
