Livn Tower 700 Wi-Fi handleiding
Handleiding
Je bekijkt pagina 5 van 32
SECTION 3: OPERATION
3.1 General introduction of the smart control
This heater has an integrated Wi-Fi control box with a touchscreen glass surface on top of the
heater. There is no other additional thermostat needed to control the heater. Once the heater
has been connected to the APP, the smartphone will take control and communicate with the
control box. If your home internet is not working, it is still possible to operate the heater via the
control box manually, once the heater is re-connected to the Wi-Fi, the smart phone will take
control again.
3.2 Control box and display description
1. Temperature display
2. “+” button
3. “-” button
4. Timer button
5. Wi-Fi signal indicator
3.3 Manual Control via touch screen buttons
Power on the heater, the screen will show the current room temperature reading, adjust your
desired room temperature by pressing the “-” or “+” button.
To set up the timer manually, you can press the Timer button, and the screen will show “1H”-
meaning the heater will operate on the countdown timer and will power off after 1 hour. Press again
to shift to “2H”, then “3H” and so on (up to 24 hours).
Press and hold the “+” button for 3 seconds to enter to the stand-by mode(screen shows “- - -“),
press and hold the “+” button for 3 seconds to quit the stand-by mode. Under stand-by mode there
will be no heat output.
3.4 Child lock
Press the “+” and “-” button together for 3 seconds to activate the child lock mode, the screen will
show “CL”. Press the “+” and “-” again to quit the child lock mode.
3.5 Open window detection
This heater has the function of open window detection, by default the function was off and you can
activate the “open window detection” after connecting your heater to the APP. When the function is
on, the heater will monitor your heating system, in case there is a dramatic temperature decreasing
in a short period, “OPE” will flashing on the screen, the system will shut off the heater for 30 minutes
and then back to normal operation. By pressing any button in between the heater will go back to
normal operation.
3.6 Temperature calibration
Power on the heater, the temperature reading will display on the screen, press and hold the Timer
button for 5 seconds to enter the temperature calibration, edit the number by pressing the “+” or “-”
button (you can adjust between +5/-5 degree).
Bekijk gratis de handleiding van Livn Tower 700 Wi-Fi, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livn |
| Model | Tower 700 Wi-Fi |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5042 MB |
