Livn Basic 10 handleiding
Handleiding
Je bekijkt pagina 7 van 50
2.4 Preparing the thermostat slot and laying the subfloor and heating film
1. Make sure the floor is clean and free from dust.
2. If the heating film is installed on a concrete or cement subfloor that is not yet completely dry, or
in a humid environment, we recommend installing a vapour-resistant foil on the base floor.
3. Cut a track in the wall from the thermostat with a curve into the floor. The slot should be cut to
the middle of a strip of heating foil, about 50 cm from the wall. Place a flexible pipe in the cut track.
4. Place the floor sensor in the flexible tube. The end of the sensor is visible at the end of the flexible
tube, but does not stick out! Place the sensor in the middle of a strip of heat foil.
5. Check the surface of the floor. For good contact and to prevent damage, it must be nice and flat.
Maximum deviation +/- 1 mm per metre.
6. If there are any irregularities in the floor, level them (for example with levelling compound).
7. Fill the slot with the flexible pipe and filling material (tile adhesive, levelling compound, etc.).
8. Make sure the floor surface is clean, dry, free of dust and grease.
9. Place the insulating subfloor. It must cover the entire floor area!
10. Tape the corners with the separately purchased tape to prevent the insulation from sliding. Leave
about 30 mm space for the power wires. Make sure that the floor is clean and that no sharp objects
can come into contact with or fall on the heating foil during installation. Plan the work in such a
way that it is not necessary to step over or onto the foil.
11. Unroll the heating foil.
12. Cut the heating film, you should cut the heating film along the dotted line.
13. Take notice that the length of your heating film in an unbroken line should be not over the
installable maximum length.
*Do not have heating film overlapped during installation. Make sure that the interval between
heating film be 1 cm – 3 cm.
14. Cover the exposed copper ends, where no connecting wires will be connected, with a piece of
black insulating tape (check the laying schedule on the next page).
15. Roll the next piece of foil parallel to the first. Tape the heating-film elements to the insulation
subfloor to prevent them from shifting during further installation.
12
13
14
Installable maximum length of heating film in an unbroken line
100 cm wide heating film: 5 – 6 m (Length)
Bekijk gratis de handleiding van Livn Basic 10, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livn |
| Model | Basic 10 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15727 MB |
