Livarno Lux IAN 390580 handleiding
Handleiding
Je bekijkt pagina 14 van 77
14 GB/IE
Risk of leakage of batteries/
rechargeable batteries
Avoid extreme environmental conditions and
temperatures, which could affect batteries/
rechargeable batteries, e.g. radiators/direct
sunlight.
If batteries/rechargeable batteries have
leaked, avoid contact with skin, eyes and mu-
cous membranes with the chemicals! Flush im-
mediately the affected areas with fresh water
and seek medical attention!
WEAR PROTECTIVE GLOVES!
Leaked or damaged batteries/
rechargeable batteries can cause
burns on contact with the skin. Wear suitable
protective gloves at all times if such an event
occurs.
In the event of a leakage of batteries/recharge-
able
batteries, immediately remove them from
the product to prevent damage.
Only use the same type of batteries/recharge-
able batteries. Do not mix used and new bat-
teries/rechargeable batteries.
Remove batteries/rechargeable batteries if the
product will not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery/re-
chargeable battery!
Insert batteries/rechargeable batteries ac-
cording to polarity marks (+) and (-) on the
battery/rechargeable battery and the product.
Use a dry lint-free cloth or cotton swab to
clean the contacts on the battery/rechargea-
ble battery and in the battery compartment
before inserting!
Remove exhausted batteries/rechargeable
batteries from the product immediately.
Before first use
Note: Remove all packaging materials from the
product.
Inserting/replacing batteries
(see fig. B)
Turn the product over and place it on a soft
underlay to avoid scratching the surface.
Open the battery compartment
6
by sliding
out the battery compartment cover
5
against
the direction of the switch
7
. See the indicated
arrow (see fig. B).
Reinstall the batteries if necessary and then c
lose
the battery compartment
6
. The product is
now ready for use.
Note: Make sure you insert the batteries with
the correct polarity. This is indicated in the
battery compartment
6
.
Use
Connect the plug
3
to the connector
4
.
Install the lamp holders
2
to back side of the
houses (see fig. A).
Your product is now ready for use.
Switching on and off
The switch
7
has three functions:
Slide the switch
7
to set the product to
TIMER, the product lights glow permanently for
6 hours and will be followed by a subsequent
pause of 18 hours. Afterwards, the product
will light up again at its designated turn on time
for 6 hours followed by a subsequent pause
of 18 hours.
Slide the switch
7
to set the product to ON,
the product glows permanently.
Slide the switch
7
to set the product to OFF,
the product is switched off.
Cleaning and care
Do not clean the product with water or other
liquids.
Use a feather duster for cleaning purposes.
Bekijk gratis de handleiding van Livarno Lux IAN 390580, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | IAN 390580 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6994 MB |
