Livarno Lux IAN 285599 handleiding
Handleiding
Je bekijkt pagina 17 van 58
16 GB/IE
Safety / Preparation / Prior to installation / Start-up
Prevent fire and injury
hazards
RISK OF INJURY! Check each lamp and lamp
glass for damage immediately after unpacking.
Do not mount the light with defective lamps
and / or lamp lenses. Should this be the case,
contact the service centre for a replacement.
Do not look directly into the light source (lamp,
LED etc.).
CAUTION! RISK OF BURNS
DUE TO HOT SURFACES! Ensure
the light has been switched off and
has cooled before touching it to avoid burns. Lights
develop a lot of heat around the lamp head.
Allow the light to cool off completely.
Replace defective bulbs with new ones immedi-
ately. Before changing lamps, always first remove
the fuse or switch off the circuit breaker.
The light bulbs provided are not
suitable for dimmers or electronic
switches.
For your safety
Only use the LED light bulbs specified in the
chapter “Technical data“.
Mount the light so that it is protected from mois-
ture and dirt.
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never install the light if you are having difficulty
concentrating or do not feel well.
Preparation
Required tools and material
The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature of
the material is determined by the individual local
conditions.
- Pencil / marking tool
- Voltage tester
- Screwdriver
- Electric drill
- Drill (ø 6 mm)
- Side cutting pliers
- Ladder
Prior to installation
Important: The electrical connection must be
performed by a qualified electrician or a person
trained in electrical installations. This person must
be familiar with the properties of the light and the
connection regulations.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the light
itself, before you install it.
Before installation ensure that the circuit, to which
the light will be connected, is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box 0 position.
Use the voltage tester to verify the de-energised
status.
Start-up
Mounting the light
Remove the locating screws
3
visible at the side
of the connection housing
6
and remove the
mounting bracket
2
at the back.
Remove the cap nuts
11
and the silicone rings
10
from the support
6 a
.
CAUTION! When removing the cap nuts
11
,
hold the screw
5
at the reverse side and the
support
6 a
, as these will also be loosened.
Now screw the spacers
7
onto the screw.
Secure the illuminant
15
in the socket and install
with a
turn clockwise.
Verify it is seated correctly.
Start-up / Maintenance and Cleaning
Bekijk gratis de handleiding van Livarno Lux IAN 285599, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | IAN 285599 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 5431 MB |
