Livarno Lux IAN 273536 handleiding
Handleiding
Je bekijkt pagina 9 van 39
9 GB/IE
but only provide approx. 25 % of their full light power (eco mode). When fully
charged, the batteries will provide approx. 8 hours of light in this setting.
Position „PIR“: The solar cell charges the batteries in sunlight. The solar cell
1
automatically
switches the spotlight on in twilight or the dark when the motion sensor
7
de-
tects movement. The light ON time is preset to approx. 1.5 minutes. If additional
movement is detected during these 1.5 minutes, the light ON time will reset. In
this setting the LEDs will be fully powered. With the batteries fully charged the
charge on this setting will provide light for a total of approx. 2 hours.
Maintenance / changing batteries
To ensure good solar cell
1
performance the solar cell must be cleaned regularly (see „Cleaning
and care“).
Change the batteries according to the instruction in Fig. B and C.
Slide the switch
12
to the „OFF“ position.
Remove the batteries from the battery compartment
10
and replace with new rechargeable
batteries with the same technical data. Be sure to insert the batteries in the correct direction. The
correct polarity is shown inside the battery compartment.
Winter-time use
The low amount of sunlight may reduce the light ON time at night depending on the on-time. Due to
the low position of the sun please also verify the solar cell
1
is out of shade throughout the day in
winter and remove ice and snow as necessary.
If the light ON time is inadequate due to the weather, recharge or replace the batteries (see„Charging
the rechargeable
batteries“ or „changing batteries“).
Cleaning and Care
Switch off the LED solar spotlight before cleaning.
Use a slightly dampened, lint-free cloth and mild cleaning agent to clean.
Regular check the sensor
7
and solar cell
1
particularly for dirt.
Regularly clean the sensor and solar cell to ensure proper functionality.
Especially keep the solar cell free of snow and ice in winter.
Troubleshooting
= Problem
= Cause
= Solution
Light doesn‘t come on.
Switch
12
set to „OFF“ position.
Set switch to “ECO” / “PIR” position.
Dirty sensor
7
.
Clean motion detector.
Batteries are drained.
Charge batteries (see „Charging the rechargeable batteries“).
Bekijk gratis de handleiding van Livarno Lux IAN 273536, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | IAN 273536 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 2861 MB |
