Livarno Lux IAN 110595 handleiding
Handleiding
Je bekijkt pagina 25 van 29
25 GB
Safety / PreparationIntroduction
Safety
Safety notices
Damage due to failure to comply with these operat-
ing instructions will invalidate the warranty! We ass
ume
no liability for consequential damage! We assume
no liability for material damage or personal injury
due to improper handling or failure to comply with
the safety instructions!
Do not leave the light or packaging material ly-
ing unattended. Plastic film or bags, plastic parts,
etc. can be dangerous for children to play with.
Avoid the risk of fatal injury
from electric shock
Ensure that a qualified electrician, or a person
trained to carry out electrical installations, per-
forms the electrical installation.
Always check the light, power supply, and mains
cable for damage before plugging it in. Never
use the light if it shows any signs of damage.
CAUTION! A damaged mains cable indicates
a life-threatening danger due to electric shock.
In the event of damage, repairs or other prob-
lems with the light please contact the service
centre or a qualified electrician.
Prior to installation, remove the fuse or switch off
the circuit breaker (0 setting) in the fuse box.
Prior to installation, verify the available mains
voltage corresponds with the operating voltage
required for the light (230 V∼ (14100702L or
14100808L) or 230–240 V∼ (14100902L or
14101008L)).
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the light on a wet or conductive
substrate!
The connecting leads must be covered with the
included rounding wires.
Prevent fire and injury
hazards
RISK OF INJURY! Check each lamp and lamp
glass for damage immediately after unpacking.
Do not mount the light with defective lamps
and / or lamp lenses. Should this be the case,
contact the service centre for a replacement.
Do not look directly into the light source (lamp,
LED etc.).
RISK OF BURNS! Ensure the light
h
as been switched off and has cooled
before touching it to avoid burns.
Lights develop a lot of heat around the lamp
head.
Allow the light to cool off completely.
Replace defective bulbs with new ones immedi-
ately. Before changing lamps, always first remove
the fuse or switch off the circuit breaker.
Safe working
Only use 220–240 V∼ LED lamps with a
GU10 base and a maximum output of 2.7 W
(14100902L or 14101008L).
Mount the light so that it is protected from mois-
ture and dirt.
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never install the light if you are having difficulty
concentrating or do not feel well.
Preparation
Required tools and material
The tools and materials specified are not included.
This information and these values are non-binding
Bekijk gratis de handleiding van Livarno Lux IAN 110595, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | IAN 110595 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 3010 MB |
