Livarno Lux HG09583A handleiding
Handleiding
Je bekijkt pagina 21 van 147
21 GB/IE
If the illuminants fail at the end of their lives, the entire product must
be replaced.
Only to be installed outside arm reach.
Danger to life by electric shock
Always check the product for damage before connecting it to the
mains. Never use the product if it shows any signs of damage.
Prior to installation, verify that the mains voltage on site corresponds
with the operating voltage required for the product (230 V∼ 50 Hz).
Otherwise do not install the product.
CAUTION! DANGER OF BURN INJURIES! To prevent burns,
verify the product is switched off and has cooled down for at least
15 min before touching it. The product can become very hot.
1 .0 m
FIRE HAZARD! Fit the product so that it is at least
1.0 m away from the material to be illuminated. Excessive
heat can result in a fire.
CAUTION! RISK OF INJURY! Broken lamp glass must
be replaced before any further use is made of the product.
The spot light is only suited for use with the built in LED control gear.
Before installation
Note: Remove all packaging materials from the product.
Important: The electrical connection must be established by a qualified
electrician or a person trained to perform electrical installations. This person
must be familiar with the properties of the product and the connection reg-
ulations.
Before installation ensure that the circuit, to which the product will be
connected, is not energised. To do so, remove the fuse or switch off the
circuit breaker in the fuse box (0 position).
Use a voltage tester to verify the de-energised status.
Bekijk gratis de handleiding van Livarno Lux HG09583A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | HG09583A |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9060 MB |
