Livarno Lux HG05408A handleiding
Handleiding
Je bekijkt pagina 17 van 96
17 GB/IE
Only use the same type of batteries/recharge-
able batteries. Do not mix used and new bat-
teries/rechargeable batteries.
Remove batteries/rechargeable batteries if the
product will not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery/recharge-
able
battery!
Insert batteries/rechargeable batteries accord-
ing to polarity marks (+) and (-) on the battery/
rechargeable battery and the product.
Use a dry lint-free cloth or cotton swab to clean
the contacts on the battery/rechargeable battery
and in the battery compartment before inserting!
Remove exhausted batteries/rechargeable bat-
teries from the product immediately.
KEEP BATTERIES OUT OF THE
REACH OF CHILDREN! Swallowing
batteries can cause chemical burns,
perforation of soft tissue, and death. Severe
burns may occur within 2 hours of swallowing
batteries. Seek immediate medical attention.
Use (see Fig. A)
Note: Remove all packaging materials from the
product.
Note: The LEDs are connected in series. If one
LED is defective, up to ten LEDs may not light up.
Insert the plug on end of the product into the
socket of the mains adapter
3
. Please screw
down the connecting nut
5
clockwise.
Insert the mains adapter
3
into the mains soc
ket;
the adapter indicator light up at the same time.
Press the Timer and mode button
2
to switch
on the light chain
1
.
Press the Timer and mode button
2
again to
switch to the next lighting mode. When you reach
lighting mode 8, the next press of the Timer and
mode button
2
switches the product off.
The light mode is listed as below:
1. Combination
2. In wave
3. Sequential
4. Slo-Glo
5. Chasing/flash
6. Slow fade
7. Twinkle/flash
8. Steady on
9. off
Pull the mains adapter
3
out of the mains socket
to completely switch off the light chain
1
.
Switching the product on/off
using the IR remote control
N
ote: The infrared receiver is located on the ad
apter.
Always aim the IR remote control
4
directly at the
receiver
9
for best reception.
Note: Remove the insulating strips from the battery
compartment
7
before using the IR remote control
4
for the first time.
Ensure that there are no obstacle between the
sender and the adapter.
Press the ON button
4 a
on the IR remote
control
4
to turn on the LEDs.
Press the OFF button
4 a
on the IR remote
control
4
to switch off the LEDs.
Controlling the light effects using
the IR remote control
The following functions are available:
Button +: Increase lights intensity
Button -: Reduce lights intensity
Button 1: Combination
Button 2: In wave
Button 3: Sequential
Button 4: Slo-Glo
Button 5: Chasing/flash
Button 6: Slow fade
Button 7: Twinkle/flash
Button 8: Steady on
Note: The off button
4 a
on the IR remote control
4
is only suitable for switching off temporarily.
To switch off permanently, remove the power adapter
3
from the socket.
Bekijk gratis de handleiding van Livarno Lux HG05408A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | HG05408A |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10168 MB |
