Livarno Lux 864 handleiding
Handleiding
Je bekijkt pagina 45 van 90
45
GB/IE/NI/CY/MT
similarly qualied person.
Never look directly into the light source.
Do not connect the product to a power
source while still inside the packaging.
There is a risk of overheating!
WARNING! DO NOT USE THE LIGHT
CHAIN UNLESS ALL SEALING RINGS
HAVE BEEN PROPERLY MOUNTED.
The operating unit is intended exclusively for
use with LED modules.
The control gear of this product may only
be replaced by the manufacturer, its
designated service technician, or a similarly
qualied person.
TRIPPING HAZARD!
Please make
sure that the power cable
2
is
routed in such a way that nobody
can tread on it or trip over it.
z Assembly and installation
Please note:
Take the product out of its
packaging and remove all packing material.
Check that all package contents are present.
Check if the product or individual parts are
damaged. Should you detect damage, do
not use the product. Please contact the
retailer via the service address indicated.
FIRE HAZARD!
Never hang the product above an
open re or heat source. This may
damage the product and excessive heat
build-up can cause a re.
RISK OF DAMAGE!
Take sufcient measures to secure
the product from falling down.
Connect power supply
RISK OF ELECTRIC SHOCK!
Plug the connector
5
into the
socket
6
of the mains plug
1
(see
Fig. B).
Tighten the union cap
4
on the screw
thread of the connection socket
6
�
Plug the mains plug
1
into a socket that
has been correctly installed.
Please note:
When using outdoors, plug
the mains plug
1
in to an IPX4 socket to
ensure splash protection.
z Operation
DANGER OF OVERHEATING!
Do
not operate the product while it is
still inside the packaging!
Please note:
Only use the product with the
supplied mains plug. Do not connect the
product or the mains plug to any external
devices.
Please note:
The product stays lit as long as
it is connected to the power supply. If you
unplug it, the product will automatically
switch off.
Timer function
To activate the timer function, keep the
button
7
on the mains plug
1
pressed
down until the LED light turns green (see
Fig. C). The timer has now been activated.
When the timer function is switched on, the
product is switched on for 6 hours and then
switched off for 18 hours.
Replacing the LEDs
RISK OF ELECTRIC SHOCK!
Incorrect handling of the product or
incorrect installation may potentially
result in personal injury.
The light source of this product may only be
replaced by the manufacturer, their
designated service technician, or a similarly
qualied person.
Remove mains plug before changing bulb.
It is essential to ensure that all interfaces
are tted with an LED.
Faulty bulbs must be immediately replaced
with bulbs of the same type as the one
Bekijk gratis de handleiding van Livarno Lux 864, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | 864 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9701 MB |
