Livarno Lux 1002 handleiding
Handleiding
Je bekijkt pagina 50 van 100
50
GB/IE/NI/CY/MT
casing and screw the cover plate
12
back
onto the outdoor spotlight.
Position the cable grommet
15
between the
cover plate and nut so as to obtain the best
possible seal and x it in place by
hand-tightening the gland nut
11
�
Slot the outdoor spotlight onto the wall
bracket
16
from above and screw it to the
bracket using the two screws (10mm)
21
(see Fig. G).
Note:
The screw heads of the cover plate
must be countersunk so that the outdoor
spotlight can be tted onto the wall bracket.
Switch the circuit-breaker for the circuit back
on or replace the fuse.
Setting the beam width
Tilt the LED module
1
into the desired
position (see Fig. H).
z Operation
The outdoor spotlight is operated by means
of the three control knobs on the bottom end
of the light (see Fig. B).
Push the ON/OFF/AUTO button
13
(see
Fig. D) into position ‘II’ for permanent light
mode. Push the ON/OFF/AUTO button
into position ‘0’ to switch the product off.
Turn the ON/OFF/AUTO button into
position ‘I’ for automatic (motion detector)
mode. When the product is in automatic
mode, you can select the following settings:
Setting the detection range
Turning the SENS control
5
(see Fig. B)
clockwise increases the detection range so
that the motion sensor responds to
movement as far away as approx. 12m.
Turning the SENS control
5
anticlockwise
decreases the detection range so that the
motion sensor only responds to movement
as close as approx. 0.5m.
Setting the burn time
Turning the TIME control
4
(see Fig. B)
clockwise increases the illumination time
(max. 1 minute).
Turning the TIME control
4
anticlockwise
decreases the illumination time (min.
10 seconds).
Setting the sensitivity of the twilight
sensor
Turning the LUX control
3
(see Fig. B)
clockwise increases the sensitivity so that
the motion sensor will respond even in
brighter ambient light conditions (e.g.
daylight).
Turning the LUX control
3
anticlockwise
decreases the sensitivity so that the motion
sensor will respond only in darker ambient
light conditions (e.g. at night).
z Cleaning and storing
RISK OF BURNS!
The light becomes hot
when switched on.
Always allow the outdoor spotlight to
completely cool down before cleaning it.
SHORT-CIRCUIT RISK!
Water penetrating
into the casing can potentially cause a
short circuit.
Before cleaning, remove the mains fuse or
switch off the circuit-breaker for the circuit to
isolate the outdoor spotlight from the mains
power supply. Use a voltage tester to check
that the outdoor spotlight is isolated from
the power supply.
Do not immerse the outdoor spotlight in
water.
Make sure that no water gets into the
casing.
RISK OF DAMAGE!
Cleaning the outdoor
spotlight incorrectly can potentially cause
damage.
Do not use corrosive cleaning agents,
brushes with metal or nylon bristles or sharp
Bekijk gratis de handleiding van Livarno Lux 1002, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | 1002 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11095 MB |
