Lincoln Electric RealWeld handleiding
Handleiding
Je bekijkt pagina 15 van 52
A-5
INSTALLATIONREALWELD
®
TRAINER
17. Adjust the platform to suitable height for safe operation.
18. Ensure the pawl is active on the ratchet when raising the carriage.
Flip the pawl up so it is not engaged with the ratchet for lowering,
this is accomplished by putting a small load on the crank. See
Figure A.20.
NOTE: The carriage pawl must be active when raising.
19. Release clamp on the carriage rack to unlock the rack and pinion.
Be sure to keep one hand on the crank while performing this
operation. See Figure A.21.
20. With the platform adjusted to the desired height, flip the pawl onto
the ratchet and lock the clamp on the rack.
21. Attach the current transducer to the ground cable. If welding
polarity is DCEP, the positive (+) side of the current transducer
faces the jig platform. If welding polarity is DCEN*, the positive
(+) side of the current transducer faces the welder. See Figure
A.22.
* When welding in DCEN, make certain the ground cable is connected
to the positive output stud on the power source.
22. Connect the female y-splitter cable connector to the gun trigger
pigtail. See Figure A.23.
23. Connect the male y-splitter cable connector to the 4-pin
receptacle on the welder. See Figure A.23.
RATCHET
PAWL
CRANK
CARRIAGE
Figure A.20 – Pawl and ratchet
CURRENT
TRANSDUCER
Figure A.22 – Current transducer
CARRIAGE
RACK
CLAMP
Figure A.21 – Carriage rack clamp
MALE FEMALE
MIG GUN
WELDER /
WIRE FEEDER
REAL
WELD
CONTROLLER
GUN TRIGGER
PIGTAIL
Y-SPLITTER
CABLE
Figure A.23 – Y-splitter cable connection diagram
Bekijk gratis de handleiding van Lincoln Electric RealWeld, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lincoln Electric |
| Model | RealWeld |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13902 MB |
