Lincoln Electric Prism Wall Mount handleiding

Niet gecategoriseerd

Lincoln Electric

36 pagina's

PDF beschikbaar

Handleiding

D-2

MAINTENANCE

FILTER REPLACEMENT

Take necessary precautions so that you

and your fellow workers are not

overexposed to particulate. Wear suitable

personal protection equipment, such as

gloves, respirator, eye glass and protective

clothing when disposing of the lter and particulate.

Check with local waste management or local agency(ies)

for assistance in the disposal of lter. If lter has

collected certain types of particulate which local

agencies dene as hazardous waste, lter may be

classied as hazardous waste and will need to be

disposed in accordance with federal, state and local

regulations - which could vary from state to state, and

between local municipalities within the state.

LONGLIFE FILTER CARTRIDGE

Replace the LongLife lter cartridge:

• when the Filter Maintenance Indicator (See Figure B.1) shows

that the lter cartridge is saturated or clogged; or

• when the airow is reduced to the point that extraction

performance is no longer satisfactory; or

• when it has been damaged.

Replacement Steps:

See Figure D.1 for steps 1-8.

1. Disconnect the extraction fan(s) from the input power.

2. Loosen latches (A) and remove the lter cover (B).

3. Unscrew the knurled nut (C) and remove the lter cover plate (D).

4. Lift the LongLife lter cartridge (E) up and out of the ltration

unit. It is not necessary to remove the prelter (F) unless it needs

replacement.

5. If required by federal, state and/or local regulations and

guidelines, conceal lter in appropriate bag, e.g. plastic bag.

6. Clean the prelter and lter compartment with an industrial

vacuum cleaner that meets OSHA guidelines for Cr6 house-

keeping.

7. Install a new LongLife lter cartridge.

8. Replace the dismounted parts in reverse order.

PREFILTER

Replace the prelter:

• when it is saturated or clogged and can’t be cleaned using a

vacuum cleaner; or

• when it has been damaged.

NOTE: In case the prelter has been damaged, it is recommended

to also replace the LongLife lter cartridge.

WARNING

TABLE D.1 – PERIODIC MAINTENANCE

COMPONENT ACTION

EVERY

MONTH

EVERY 6

MONTHS

Filter Maintenance Indicator

Unless LongLife lter cartridge is clean, check if indicator moves upwards upon

starting fan(s). If not, See Troubleshooting Section.

X [*]

Prelter, LongLife lter cartridge

and optional Activated Carbon

Filter

Check for damage, clogging and saturation. If damaged, clogged or saturated, See

Filter Replacement.

Filter cover and bottom housing

Clean inside with an industrial vacuum cleaner that meets OSHA guidelines for Cr6

housekeeping and remove the dust from the lter compartment.

Clean outside with a mild detergent. X [*]

Check for cracks or holes. If damaged, See Troubleshooting Section. X [*]

prelter

Replace every lter change or clean with an industrial vacuum cleaner that meets

OSHA guidelines for Cr6 housekeeping.

Connection hose(s) Check for cracks, holes or deformities. If damaged, See Troubleshooting Section. X [*]

Non-return valves (Dual Arm

versions only)

Check buttery aps for free movement, deformities and particulate build-up or

debris. If damaged, See Troubleshooting Section.

PRISM

WALL MOUNT

Bekijk gratis de handleiding van Lincoln Electric Prism Wall Mount, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.