Handleiding
Je bekijkt pagina 45 van 52
Setup conditions
Degrees of pollution
(surrounding the
appliance)
PD2
Ambient temperature +10 °C (50 °F) to
+35°C(95°F)
Maximum relative
ambient moisture
75%, not condensing
Maximum operating
elevation (meters
above sea level)
2000m(6,561.68ft)
1500 m (4,921.26 ft) (glass
door)
Electrical values
Nominal voltage 115-127 V~
Frequency 60Hz
Electrical values
Connected load 2,0A
Maximum power supply fluctuation +/-10%
Overvoltage categories II
9.2 Technical malfunction
Your appliance is designed and built to ensure it works
reliably and has a long service life. If a malfunction
nonetheless occurs during operation, please check
whether the malfunction is due to an operating error. If
this is the case, you will be charged for the cost
incurred even if this falls within the warranty period.
You can rectify the following malfunctions yourself.
9.2.1 Appliance function
Defect
Cause Remedy
The appliance is
not working.
The appliance is not switched on.
u
Switch on the appliance.
The power plug is not properly
inserted in the socket.
u
Check the power plug.
There is a problem with the wall
socket breaker.
u
Check the breaker.
Power failure
u
Keep the appliance closed.
u
If necessary move the refrigerated/frozen items to
another fridge or freezer if the power is off for a
prolonged period.
The IEC socket is not correctly
plugged into the appliance.
u
Check the IEC socket.
The temperature
is not cold
enough.
The appliance door is not closed
properly.
u
Close the appliance door.
Ventilation is not sufficient.
u
Unclog the ventilation grill and clean it.
The ambient temperature is too
high.
u
Observe the suitable ambient conditions:
(see1.4 Range of appliance use)
The appliance was opened too
many times or for too long.
u
Wait to see if the required temperature corrects
itself. If not, contact Customer Service.
(see 9.3 Customer Service)
The temperature is set incorrectly.
u
Set a colder temperature and check after 24 hours.
The appliance is too close to a
heat source (stove, heater etc).
u
Move either the appliance or the heat source.
Frost forming on
the housing
frame and/or on
the inside of the
door.
Door seal is damaged.
u
Replace the door seal.
You have set the temperature too
cold or you have not opened to
door often enough.
u
The appliance’s functions are not impacted; use a
cloth to remove the frost formation.
Customer support
* Depending on model and options 45
Bekijk gratis de handleiding van Liebherr SFTfg 1501 Performance, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Liebherr |
| Model | SFTfg 1501 Performance |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 6773 MB |
