Handleiding
Je bekijkt pagina 65 van 76
Figure 52. Disconnect the EDP cable from the system board
Step 3. Rotate the LCD unit to an angle of more than 90 degrees and place the computer on a flat surface
as shown. Remove four screws and then remove the LCD module.
Figure 53. Remove four screws and then remove the LCD module
Screw specifications
Number of screws
M2.5 x L5 4
Remove the upper case
Make sure the following FRUs (CRUs) have been removed.
“Remove the lower case” on page 48
“Remove the battery pack” on page 49
“Remove the solid-state drive (SSD) module” on page 49
“Remove the solid-state drive (SSD) stand off” on page 50
“Remove the Wi-Fi card” on page 51
“Remove the heat sink” on page 52
Chapter 4. Removing a FRU or CRU 59
Bekijk gratis de handleiding van Lenovo V15 Gen 4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lenovo |
| Model | V15 Gen 4 |
| Categorie | Laptop |
| Taal | Nederlands |
| Grootte | 19204 MB |
