Leifheit Dry & Clean 51001 handleiding

Handleiding

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172/ 72

Afdrukken

Je bekijkt pagina 45 van 72

45 GB

3. PROPER USE

• Please note that this product is only intended for household use. Leifheit does not provide a manufacturer‘s warranty for commercial use.

• Only use this device for cleaning wet, smooth surfaces, such as windows, mirrors and tiles.

• No dust may be sucked in.

• Do not use the window cleaner on rough surfaces so as to avoid damage to the rubber lip.

• Thedeviceisnotsuitableforsuctionoflargequantitiesofuidsabove100ml,ammableorstickyuids.

• Only use this device in connection with conventional window cleaning agents (no spirits, no foam cleaner). We recommend: Leifheit

Glass Cleaning Liquid or Window Spray.

• Only use this device with the accessories and spare parts approved by Leifheit.

Any other use is considered to be improper. The manufacturer is not liable for damages resulting from improper use. The user alone

shall bear the risk for this.

Figure 2: Window cleaner operating controls

Suction nozzle

Dirty water tank

(removable)

Side tank valve

for draining

Tank release button

Operation / battery charge display

Appliance switch (on / off)

Charging connector

Handle receptacle for all Leifheit ClickSystem handles

4. START-UP / CHARGING THE BATTERIES

• The window cleaner is not delivered with a fully charged battery. Therefore, please fully

chargethebatterypriortotherstuse.

• The battery reaches full capacity after some full charges and use cycles.

• Attach the suction nozzle to the tank. Push the two accompanying locking tabs into the tank‘s

upper surface until you hear the connection make an audible click. The visible screws should

befacingdowninthisposition(seegure3).

• Beforeyouchargethedevice,pleaseensurethatthedeviceisswitchedoff(seegure4).

• Connect the charger to the charging connector. Plug the charger into the socket. The LED

displaywillashgreenwhilethecharging.

The LED will be solid green once the battery is fully charged.

• The battery may only be charged by using the supplied charger.

• The charger is only to be used in connection with the Leifheit window cleaner.

• Always charge the rechargeable battery after work and always store the device fully charged.

5. USE

1. Suction clean the surface

• Clean the window as usual with water and a cleaning agent. Switch the window vacuum on

by pushing the main power switch; the indicator light will be a steady green. Place the rubber

lip of the device on the surface to be vacuumed and use light pressure to pull it from top to

bottom across the surface. To achieve the best results, hold the appliance at a 45° angle to

thepane(seegure5).

• Hard-to-reach surfaces can be suctioned either from top to bottom, sideways or upside down.

If a windowsill or very wide window frames prevent or hinder a vacuuming to the bottom edge

of the window pane, vacuum across the pane once at the end of the vacuuming process.

Base

Rubber wiping blade

Battery compartment

Figure 5

45°

Figure 3:

Attaching the

suction nozzle

Figure 4:

Appliance

switch in the

off position

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172/ 72

Bekijk gratis de handleiding van Leifheit Dry & Clean 51001, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Stoomreiniger