Lectrosonics SMV/941 handleiding
Handleiding
Je bekijkt pagina 17 van 24
Super-Minature Belt Pack Transmitter
Rio Rancho, NM
17
Straight Whip Antennas
This is a full size cutting template used to cut the length
of the whip for a particular frequency. Lay the uncut an-
tenna on top of this drawing and trim the whip length to
the desired frequency.
After cutting the antenna to the desired length, mark the
antenna by installing a color cap or sleeve to indicate the
color listed in the table below
The supplied caps can be used several dierent ways:
1) A color cap on the end of the whip
2) A color sleeve next to the connector with a black
cap on the end of the whip (trim the closed end of
the colored cap o with scissors to make a sleeve).
3) A color sleeve and color cap (cut the cap in half
with scissors).
21
22
23
24
25
26
27
28
29
20
19
470
944
Note: Check the scale of your printout. This line should be 6.00 inches long (152.4 mm).
Whip Length
NOTE:
Not all Lectrosonics products are built on all of the blocks covered in
this table.
Factory supplied antennas precut to length include a label with the
frequency range. Label is not supplied with this kit.
470 470.100 - 495.600 Black w/ Label 5.67”
19 486.400 - 511.900 Black w/ Label 5.23”
20 512.000 - 537.500 Black w/ Label 4.98”
21 537.600 - 563.100 Brown w/ Label 4.74”
22 563.200 - 588.700 Red w/ Label 4.48”
23 588.800 - 614.300 Orange w/ Label 4.24”
24 614.400 - 639.900 Yellow w/ Label 4.01”
25 640.000 - 665.500 Green w/ Label 3.81”
26 665.600 - 691.100 Blue w/ Label 3.62”
944 944.100 - 951.900 Black-w/Label 2.62”
BLOCK FREQUENCY CAP/SLEEVE ANTENNA
RANGE COLOR WHIP LENGTH
Bekijk gratis de handleiding van Lectrosonics SMV/941, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lectrosonics |
| Model | SMV/941 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5751 MB |
