LD Systems ANNY 10 BATTERY handleiding
Handleiding
Je bekijkt pagina 4 van 48
GENERAL
QUICK START GUIDE
4 LD ANNY 10 BATTERY QSG
• Do not modify the battery and do not attempt to
replace battery cells.
• Do not damage battery cells or battery packs. Do
not use damaged battery cells or battery packs.
• Do not remove protective films from batteries or
battery packs.
• Do not insert any foreign objects into the bat-
tery. Do not allow any liquids to enter the bat-
tery.
• If the device or the battery becomes deformed
or overheats, switch it off immediately.
• Avoid strong mechanical impact on the device,
such as dropping, smashing or puncturing as
well as high pressure.
• Only charge the device or battery in the inten-
ded manner. Only use the original charger sup-
plied by the manufacturer.
• Note that the charging function may not deac-
tivated by the main device switch.
• In case of charging devices integrated in flight
cases, leave the case lid open while charging.
• Spilled liquids from batteries are corrosive, may
be toxic, and can cause skin and eye irritations.
Avoid any contact with spilled liquids from bat-
teries. If you had contact with spilled liquids
from batteries, wash the affected area immedi-
ately with plenty of water and consult a doctor.
• Do not attempt to charge non-rechargeable bat-
teries.
• Do not short-circuit batteries and rechargeable
batteries. Avoid contact between the battery ter-
minals and electrically conductive objects, such
as key rings or coins.
• Ensure correct polarity when inserting batteries
and rechargeable batteries. For correct polarity
see the illustrations in the battery compartment
or on the housing.
• Do not use different cell types and battery
brands in one device at the same time.
• Only use batteries and rechargeable batteries
with the same discharge status.
CHARGING, OPERATING, AND STORING BATTERIES
• Devices with lithium batteries are equipped with
the usual protective devices.
• The charging time for a full charge of the battery
can be found in the user manual under Technical
Data. Information on displaying the battery
charge status can be found under Operation
• Do not charge, operate, or store the battery out-
side the ambient conditions specified in the
user manual under Technical Data.
• Fully recharge the battery as soon as possible
after discharging.
• Only store the device with a fully charged bat-
tery. Batteries that are not fully charged can
lose capacity and service life prematurely.
• If the device is not used for a longer period of
time, carry out a complete discharge and charge
cycle at least every 3 months.
• The main power switch must be switched off
during storage.
• Specified battery runtimes always refer to a new
battery under normal operating conditions.
• When operating in a cold environment, the bat-
tery life may be shorter than specified.
• If the device runtime in battery mode deviates
significantly from the specifications, contact the
Adam Hall customer service.
3.6 THERMAL SAFETY
• Do not install the device near heat sources, such
as radiators or ovens.
• Do not block any ventilation openings.
• Unless otherwise stated, keep a minimum clear-
ance of at least 20 centimetres around the
device.
• Unless otherwise stated, keep flammable mater-
ials, such as paper or wood, at least 50 centi-
metres away from the device
3.7 DEVICE SAFETY
• Do not switch the device on and off in quick suc-
cession, because this will shorten the device life-
time.
Bekijk gratis de handleiding van LD Systems ANNY 10 BATTERY, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | LD Systems |
| Model | ANNY 10 BATTERY |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4758 MB |
