Handleiding
Je bekijkt pagina 9 van 20
9
OPERATING INSTRUCTIONS
STARTING THE HEATER
1. Fill the fuel tank until the fuel gauge points to “F”.
2. Ensure the fuel cap is securely tightened.
3. Plug the mains lead into a suitable power socket and turn the mains switch on.
4. Push the Power switch on the control panel to the “ON” ( I ) position.
Note: The temperature that the thermostat is set to will be shown on the display: If the set temperature is lower than
the ambient temperature, the heater will not run and after a few seconds the ambient temperature will show on the
display.
5. To start the heater, turn the thermostat control clockwise to raise the set temperature (as shown on the display)
above the ambient temperature and the heater will run. If the set temperature is higher than the ambient
temperature the heater will start to run.
6. Once running the ambient temperature will show on the display.
The set temperature can be adjusted at anytime during operation; Turn the thermostat control left to lower the
temperature and clockwise to raise the temperature, at this time the temperature on the display indicates the set
temperature and after a few seconds it will change to the ambient temperature.
The heater will run until the ambient temperature goes above the set temperature, at which point the heater will
automatically stop running until the ambient temperature drops below the set temperature, or the thermostat is
turned up.
STOPPING THE HEATER
1. Turn the power switch to the “OFF” ( 0 ) position.
2. Combustion will stop and the cooling cycle will begin.
3. When cooling cycle has been completed and the fan stops running (approximately 3 minutes), it is safe to turn
o and unplug the heater at the mains supply.
WARNING! Do not turn the mains switch o or disconnect the heater from the mains supply to
stop the heater or until the cooling cycle is complete. Turning the mains switch o, or removing
the plug from the mains supply to stop the heater or before the cooling cycle is complete may
cause overheating, possible damage to the heater and will void the warranty.
LAVOR - IRH-70
USER MANUAL
70,000BTU - Industrial Radiant Heater
www.lavorwash.com.au
Bekijk gratis de handleiding van Lavor IRH-70, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lavor |
| Model | IRH-70 |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 3752 MB |
