Laserworld CS-1000RGB handleiding

Handleiding

1234567891011121314151617181920212223/ 23

Afdrukken

Je bekijkt pagina 7 van 23

Laserworld CS-1000RGB MK4 Laserworld CS-1000RGB MK4

12 / 45 13 / 45

Channel Value Function

14 No use

15 Operation mode 0 - 199 DMX mode, CH 1 - 18 available

200 - 224 Sound mode, CH 1 & CH 16 - 18 available

225 - 255 Auto mode, CH 1 & CH 16 - 18 available

16 Red adjust 0 - 255 Red brightness adjust 100~0% (also aects sound and auto

mode)

17 Green adjust 0 - 255 Green brightness adjust 100~0% (also aects sound and auto

mode)

18 Blue adjust 0 - 255 Blue brightness adjust 100~0% (also aects sound and auto

mode)

8.2.5. SETTINGS

To access the settings, select „SEt“ by navigating with the „Up“ / „Down“ buttons and conrm with

„Enter“:

The settings menu holds several conguration options for the laser system.

Master Setting

The „uAST“ menu allows for the activation and deactivation of the Master mode for the laser. If

the laser is set to Master > On, then it can be used as Master device in a Master-Slave setup. See

more in „8.2.3. Master-Slave“.

Press „Enter“ to change the settings. Use the „Up“ / „Down“ button to change the selection.

Conrm with „Enter“.

Safety Setting

The „bEAu“ menu can switch the beam block safety on and o󰀨. The beam block safety prevents

that very intense, single beams can be displayed. It is highly recommended to not switch this

feature o󰀨. Switching o󰀨 the beam block safety is at your own risk! Lasers with switched o󰀨 beam

block safety may only be used in safe areas.

Always respect the local laws!

Press „Enter“ to change the settings. Use the „Up“ / „Down“ button to change the selection.

Conrm with „Enter“.

Orientation Setting

The „InvE“ menue controls the orientation of the projection. You can invert the projection and ip it

to match the orientation of the laser with the content.

Press „Enter“ to change the settings. A test picture is shown to represent the currently set orientati-

on. Use the „Up“ / „Down“ button to change the selection, and conrm the selection with „Enter“ to

change the test picture projection

Press „Exit“ to return to the settings menu.

Microphone Sensitivity Settings

The sensitivity of the built-in microphone for the control of the sound-to-light operation can be

adjusted in the „SEnS“ menu. Press „Enter“ to change the settings. Use the „Up“ / „Down“ button to

change the selection.

1234567891011121314151617181920212223/ 23

Bekijk gratis de handleiding van Laserworld CS-1000RGB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Verlichting