Lantronix AP-GET-SFP-01 handleiding
Handleiding
Je bekijkt pagina 5 van 14
Lantronix 1. Product Introduction
AP-GET-SFP-01 Install Guide 5
• PCB board assembly only, metal enclosure not provided
• 10-pin connector B10B-PH-K-S on-board header for UTP and power connections (customer supplies a
mating connector solution)
• One internal copper port status LED
• One external fiber port status LED
• Two PCB mounting holes
Operational Features
Auto-Negotiation
The AP-GET-SFP-01 Auto-Negotiation feature is permanently enabled. Auto-Negotiation allows the media
converter to configure itself automatically to achieve the best possible mode of operation over a link.
It broadcasts speed (1000 Mb/s) and duplex capabilities (full) to the other device and negotiates the best mode
of operation. Auto-Negotiation allows quick and easy installation because the optimal link is established
automatically.
Active Link Pass-Through (ALPT)
Link Pass-Through is a troubleshooting feature that allows the media converter to monitor both the fiber and
copper RX ports for loss of signal. With the loss of RX signal on one media port, the converter will automatically
disable the TX signal of the other media port, thus “passing through” the link loss.
• End device automatically notified of link loss
• Prevents loss of valuable data unknowingly transmitted over invalid link
Active LPT requires the links to become Active before LPT becomes Active. With Active LPT there are two states:
Diagnostic and Active.
The media converter enters the Diagnostic state when either of the following conditions is met:
• Upon power-up of the converter.
• Upon removing the converter’s SFP module (if equipped).
In the Diagnostic state, the link for each of the media converter’s ports can come up independently of each
other, just like a converter that has no LPT functionality, or a converter that has LPT disabled. The Diagnostic
state is helpful during first power up, before all links of a circuit are connected, as it allows the installer to see
each link turn on as the cables are plugged in. It’s also helpful for finding the location of a fault if one exists.
Note: The media converter remains in the Diagnostic state until the link status for both media converter’s ports
are up, simultaneously.
After that condition is met, ALPT enters the Active state. It remains in the Active state until the converter is
either powered down, or its SFP module is removed. In the Active state, Active LPT works as shown below.
Bekijk gratis de handleiding van Lantronix AP-GET-SFP-01, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lantronix |
| Model | AP-GET-SFP-01 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3027 MB |
