Lantronix AP-GET-SFP-01 handleiding
Handleiding
Je bekijkt pagina 12 van 14
Lantronix 3. Installation
AP-GET-SFP-01 Install Guide 12
Removing an SFP Module
CAUTION: Be careful when removing the SFP from a device. Some SFP transceiver module temperatures may
exceed 160°F (70°C) and be too hot to touch with bare hands.
Note: Do not remove and replace the SFP modules more often than necessary; excessive SFP removing and
replacing can shorten the SFP’s useful life.
1. Attach an ESD-preventive wrist strap to your wrist and to the ESD ground connector or a bare metal
surface on your chassis.
2. For future reattachment of fiber-optic cables, note which connector plug is send (TX) and which is
receive (RX).
3. Remove the SFP transceiver module:
a. If the SFP transceiver module has an actuator button latch, gently press the actuator button on
the front of the SFP transceiver module until it clicks and the latch mechanism releases the SFP
transceiver module from the socket connector. Grasp the actuator button between your thumb
and index finger, and carefully pull the SFP transceiver module straight out of the module slot.
b. If the SFP transceiver module has a bail clasp latch, pull the latch out and down to eject the SFP
transceiver module from the socket connector. If the bail clasp latch is obstructed and you
cannot use your index finger to open it, use a small, flat-blade screwdriver or other long, narrow
instrument to open the bail clasp latch. Grasp the SFP transceiver module between your thumb
and index finger, and carefully remove it from the socket.
4. Replace the Dust Plug.
5. Place the removed SFP transceiver module in an antistatic bag or other protective package.
Connecting Two-Strand Fiber Cable
Full duplex (always ON) is on the fiber side only; therefore, the 512-Bit Rule does not apply. The cable lengths
are constrained by the cable requirement.
1. Locate or build IEEE 803.2™ compliant 1000Base-X fiber cable with male, two-stranded TX to RX LC
connectors installed at both ends.
2. Connect the fiber cable to the AP-GET-SFP-01 media converters as follows:
• Connect the male TX cable connector to the female TX port.
• Connect the male RX cable connector to the female RX port.
3. Connect the fiber cable to the other device (another media converter, hub, etc.) as follows:
• Connect the male TX cable connector to the female RX port.
• Connect the male RX cable connector to the female TX port.
Two-strand Fiber Cable
Bekijk gratis de handleiding van Lantronix AP-GET-SFP-01, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lantronix |
| Model | AP-GET-SFP-01 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3027 MB |
