Handleiding
Je bekijkt pagina 28 van 58
Inspection process after installation
Inspection Process after Installation for LBERT24RCSAA,
LB-ERT30RC-S,LB-ERT36RC-S,LB-ERT36RC-B
1. Measure the voltage between L1, L2 and N. L1-L2 is 240V;L1-N is 120V; L2-N is 120V.
●
If “E1” is displayed on the screen, it means the wires L1, L2 and N are connected
incorrectly. The technician should inspect and correct the error.
●
Check if each terminal on the power cord corresponds to the L1, N, and L2 connectors
on the electric range.
2.After connecting the power, the cooling fan start running for self-testing and
completing in 10seconds.
3.Check Cooktop:Turn on the knob located on the left.The red indicator light on the left
will ON. The corresponding burner will become red within 1 minutes. The cooling fan in
the upper back will start running at the same time. Repeat the process to check the rest
knobs and burners.
●
If the burner does not become ren within 1minute, check whether the corresponding
knob is adjusted to the manimum power.
●
After the burner reaches the maximum temperature, it is a normal phenomenon that
the burner will repeat the cycle “extinguish - become red - extinguish - become red ”
automatically until you turn off the knob.
4.Check Oven
1) Select “ Broil ” option. Set the temperature to 500℉ Click “ Start ” to run the oven.
The cooling fan at the upper back of the electric range will start running at the same time.
Within 5minutes, the upper heating tube in the oven will turn red.
“Start” to run the oven. The cooling fan will also start running at the same time like the
2) Select “ Bake” option. Repeat the above steps to set the temperature to 500
℉
Click
above steps. The lower heating tube (located under the hidden elements cover ) should
3) Select “ Broil Conv. ” Option. Repeat the above steps to check whether the cooling fan
located at upper back of the electric range and the convection fan in the oven will start
running at the same time. The upper heating tube and the center heating tube hidden
near the convection fan should turen red in 5minutes.
4) Select “ Bake Conv. ” Option. Repeat the above steps to check whether the cooling fan
and convection fan will start running. The lower heating tube and the center heating tube
turn ren in 5minutes.
5) Select “ Oven Light ”, the light in the oven should turn on. Touch “ Oven Light ” button
again, the oven light should turn off.
If all the heating elements on the top and inside the oven can work well, it means your
electric range installed correctly . You can start enjoying your new electric ranges now!
if not, please check whether the household voltage is a 3-wire or 4 wire, single-phase
A.C. 208/120 Volt or 240/120 Volt, 60 hertz electrical system. And check whether the
voltage between L1, L2, and N. L1-L2 is 240V; L1-N is 120V and L2-N is 120V.
27
Bekijk gratis de handleiding van Lanbo LB-ERK24RC-B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lanbo |
| Model | LB-ERK24RC-B |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 7298 MB |
