Lamona LAM8721 handleiding
Handleiding
Je bekijkt pagina 31 van 40
31
Exclusive to Howdens
Problem Reason Solution
Programme does not start
after closing the door.
Start / Pause / Cancel touch-key was not pressed. Press the Start / Pause / Cancel touch-key.
It may be difficult to close the door in case of
excessive amounts of laundry.
Reduce the amount of laundry and make sure that
the door is closed properly.
Programme cannot be started
or selected.
Washing machine has switched to self protection
mode due to a supply problem (line voltage, water
pressure, etc.).
To cancel the programme, turn the Programme
Selection dial to select another programme.
Previous programme will be cancelled,
(see Cancelling/changing a programme).
Water in the machine.
Some water might have remained in the product
due to the quality control processes in the
production.
This is not a failure; water is not harmful to the
machine.
The machine enters standby
mode after the programme
starts or it does not take in
water.
Tap is turned off. Turn on the taps.
Water inlet hose is bent. Straighten the hose.
Water inlet filter is clogged. Clean the filter.
Door may be open. Close the door.
The water connection may be wrong or water may
be cut off (When the water is cut off, washing or
rinsing LEDs flash).
Check the water connection. If the water is cut
off, press the Start/Pause key after the water has
been supplied again to resume the operation from
standby mode.
Machine does not drain water.
Water drain hose might be clogged or twisted. Clean or flatten the hose.
Pump filter is clogged. Clean the pump filter.
Machine vibrates or makes
noise.
Machine might be standing unbalanced. Adjust the feet to level the machine.
A hard substance might have entered into the
pump filter.
Clean the pump filter.
Transportation safety bolts are not removed. Remove the transportation safety bolts.
Laundry quantity in the machine might be too little. Add more laundry to the machine.
Machine might be overloaded with laundry. Take out some of the laundry from the machine
or distribute the load by hand to balance it
homogeneously in the machine.
Machine might be touching on a rigid item. Make sure that the machine is not touching
anything.
There is water leaking from
the bottom of the washing
machine.
Water drain hose might be clogged or twisted. Check for drain hose issues.
Pump filter is clogged. Clean the pump filter.
Machine stopped shortly after
the programme started.
Water drain hose might be clogged or twisted. Un-kink / unblock hose.
Machine directly discharges
the water it takes in.
Draining hose might not be at adequate height. Connect the water draining hose as
described in the operation manual.
No water can be seen in the
machine during washing.
The water level is not visible from outside of the
washing machine.
This is not a failure.
Water enters the machine
when turned off
Drain hose incorrectly fitted to sink outlet. Turn water off at isolation valve and call service
engineer.
Cold water fill valve on machine stays open.
Problem solving (continued)
Many malfunctions and faults that can occur in daily operation can be easily remedied. Time and money will be
saved because a service call will not be required.
The following guide may help you to find the reason for a malfunction or a fault, and to correct it.
Bekijk gratis de handleiding van Lamona LAM8721, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lamona |
| Model | LAM8721 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 11963 MB |
