KStrong UFA20006 handleiding
Handleiding
Je bekijkt pagina 5 van 13
04
Small ring or other non-compatibly shaped element
1. Force is
applied to the snap
hook.
3. The gate opens
allowing the snap hook
to slip off.
2. The gate presses
against the connecting
Ring.
If the connecting element to which a snap hook (shown) or carabiner attaches is undersized or irregular in shape, a situation could occur where
the connecting element applies a force to the gate of the snap hook or carabiner. This force may cause the gate (of either a self-locking or a non-
locking snap hook) to open, allowing the snap hook or carabiner to disengage from the connecting point.
RESCUE PLAN
Ÿ Extreme Temperatures
Ÿ Gases
Please contact KStrong with any questions regarding the use of this equipment in the presence of any environmental hazard.
This equipment is not designed to be used in high temperature environments. It is important to protect this equipment
when using near activities like welding or metal cutting. Hot sparks may cause damage to this equipment or burn
it. Contact KStrong for details on use of this equipment in high temperature environments.
The application type determines the anchorage strength requirement. As per ANSI Z359.1 the necessary anchorage
strength for the following applications is listed below:
Ÿ Chemicals
CONNECTING SUBSYSTEMS
It is important to take additional precautions while using this equipment in the presence of any environmental hazards
so as to prevent injury to the user or damage to the equipment.
WARNING
Ÿ High Voltage Power Lines
A rescue plan should be well documented and in place before performing work at height. The rescue operation must be
performed by trained and competent personnel only. The rescue expert team should supervise the rescue operation
performed. It is also advised to work in pairs while working on the site.
Use only those connecting subsystems (self-retracting lifeline, lanyard, rope grab and lifeline, cable sleeves) that are
suitable for your application. See subsystems manufacturer's instructions for more information. As per OSHA, the free
fall distance should be limited to less than 6 ft., when the personal fall arrest system is used along with the equipment
mentioned in this manual. Additionally, the fall arrest force also should be less than 1800 lbs. (8 kN). Ensure the
carabiner cannot cross-gate load (load against the gate rather than along the backbone of the carabiner). KStrong
recommends use of KStrong energy absorbing lanyards along with anchors mentioned in this manual, to ensure that
the maximum fall arrest force does not exceed 1800 lbs. (8 kN), and for the proper functioning of the system.
If the equipment has been subjected to forces of fall arrest, in the event of a fall, then the equipment should be
immediately removed from service. Contact KStrong regarding any queries related to this.
ENVIRONMENTAL HAZARDS
Environmental hazards may include the following, but are not limited to:
Ÿ Corrosive Environments
Ÿ Sharp Edges
Ÿ Moving Machinery and Vehicles
WARNING
ANCHORAGE STRENGTH
Ÿ As per OSHA 1926.500 and 1910.66: anchorages that are used for attachment of Personal Fall Fall Arrest:
Bekijk gratis de handleiding van KStrong UFA20006, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | KStrong |
| Model | UFA20006 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1499 MB |
