Kramer VS-84HN handleiding
Handleiding
Je bekijkt pagina 21 van 49
18 VS-84HN - Operating the VS-84HN 8x4 HDMI Matrix Switcher
6.9 Connecting via Ethernet
You can connect to the VS-84HN via Ethernet using either of the following methods:
• Directly to the PC using a crossover cable (see Section 6.9.1
)
• Via a network hub, switch, or router, using a straight-through cable (see
Section 6.9.2
)
After connecting the VS-84HN to the Ethernet port, configure your local Ethernet port
by following the instructions in the Ethernet Configuration (K-LanConfigurator) guide
available from www.kramerav.com/support/product_downloads.asp
or from the
Downloads section of the VS-84HN Web page.
Note: If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
6.9.1 Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the VS-84HN directly to the Ethernet port on
your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the VS-84HN
with the factory configured default IP address.
6.9.2 Connecting the Ethernet Port via a Network Hub or Switch
You can connect the Ethernet port of the VS-84HN to the Ethernet port on a
network hub or using a straight-through cable with RJ-45 connectors.
6.10 Upgrading the Firmware
For instructions on upgrading the firmware see “Upgrading the VS-84HN Firmware
Using the STC Software”.
i
Bekijk gratis de handleiding van Kramer VS-84HN, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kramer |
| Model | VS-84HN |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5553 MB |
