Kramer TP-873XR handleiding
Handleiding
Je bekijkt pagina 6 van 14
Kramer Electronics Ltd.
TP-873XR / TP-874XR – Defining TP-873XR HDMI 4K Line Transmitter
4
Defining TP-873XR HDMI 4K Line
Transmitter
TP-873XR HDMI 4K Line Transmitter
This section defines TP-873XR.
Figure 1: TP-873XR HDMI 4K Line Transmitter
#
Feature
Function
IN LED
Lights green when an active source device input signal is
detected.
OUT LED
Lights green when an active, far-end sink (acceptor) output signal
is detected via the DGKAT link.
ON LED
Lights green when the device receives power.
HDMI™ IN Connector
Connect to an HDMI source.
DGKAT-2 OUT RJ-45 Connector
Connect to the DGKAT-2 IN RJ-45 connector on the TP-874XR.
SETUP DIP-switches
Set the operation DIP-switches (see Setting the DIP-Switches
on page 9).
IR 3.5mm Mini Jack Connector
Connect to an external infrared emitter / sensor for IR signal
bidirectional extension to control a remote device. For example,
connect to an external infrared sensor to control the HDMI OUT
acceptor that is connected to TP-874XR.
RS-232 (G, Rx, Tx) 3-pin
Terminal Block Connector
Connect to an RS-232 port for serial signal bidirectional extension
to the receiver. For example, connect to an SL-240C controller
device to serially control the HDMI OUT acceptor that is
connected to TP-874XR.
For firmware upgrade via the RS-232 port, contact Kramer Tech
Support.
12V DC Power Connector
12V DC connector for powering the unit when it is not powered by
TP-874XR via the DGKAT link.
1
2
3
4
5
6
7
8
9
Bekijk gratis de handleiding van Kramer TP-873XR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kramer |
| Model | TP-873XR |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2066 MB |
