Kramer RC-208 handleiding
Handleiding
Je bekijkt pagina 7 van 22
Kramer Electronics Ltd.
Ethernet and K-NET Control Keypad – Defining the Ethernet and K-NET Control Keypad
5
#
Feature
Function
DIP-Switches
For K-NET: The last physical device on a K-NET bus must be terminated.
For RS-485: The first and the last units on the RS-485 line should be
terminated. Other units should remain unterminated.
DIP-switch 1 (to the left)
K-NET Line Termination
DIP-switch 2 (to the right)
RS-485 Line Termination
Slide down (ON)
For K-NET line-termination.
For RS-485
line-termination.
Slide up (OFF,
default)
To leave bus unterminated.
To leave RS-485 line
unterminated.
Ring Tongue Terminal
Grounding Screw
Connect to grounding wire (optional).
Figure 3: Ethernet and K-NET Control Keypad Rear View
#
Feature
Function
RS-232 3-pin Terminal
Block Connectors
(Rx, Tx, GND)
Connect to RS-232 controlled devices (1 and 2, with common GND).
RS-485 3-pin Terminal
Block Connector
Connect to the RS-485 terminal block connector on another device or PC.
KNET 4-pin Terminal
Block Connector
Connect the GND pin to the Ground connection; pin B (-) and pin A (+) are
for RS-485, and the +12V pin is for powering the connected unit.
12V Power Supply 2-pin
Terminal Block
Connector (+12V, GND)
Connect to a power supply: Connect GND to GND and 12V to 12V.
For RC-308 / RC-306 only, you can also power the unit via a PoE provider.
ETHERNET RJ-45
Connector
Connect to an Ethernet LAN for control, firmware upgrade and for uploading
the configuration.
For RC-308 / RC-306 only, LAN also provides PoE.
REL 2-pinTerminal
Block Connectors
Connect to a device to be controlled by relay. For example, a motorized
projection-screen (1 and 2).
IR 2-pin Terminal Block
Connectors (Tx, GND)
Connect to an IR emitter cable (1 and 2, with common GND).
I/O 2-pinTerminal Block
Connector (S, GND)
Connect to a sensor or device to be controlled, for example, a motion
sensor. This port may be configured as a digital input, digital output, or
analog input.
Factory Reset Button
Press while connecting the power and then release to reset the device to its
default parameters. To access this button, you need to remove the Button
Faceplate.
Bekijk gratis de handleiding van Kramer RC-208, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kramer |
| Model | RC-208 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2754 MB |
