Handleiding
Je bekijkt pagina 7 van 19
Kramer Electronics Ltd.
AW-6P – Installation Guide
5
Mounting the Speaker
Prepare the speaker cable – the recommended location is behind the central hole in the U-
bracket.
Install the U-bracket in the designated location on the wall.
Mount the speaker to the U-bracket, secure it with the two toolless bracket screws that are
supplied with the speaker.
Adjust the required angle of the speaker and tighten the screws.
Wiring the Speakers – best practice
Your passive speaker features both low impedance (8Ω) and high impedance (70V/100V)
modes. Understanding the difference is essential for safe installation and optimal
performance.
Low Impedance Installation (8 Ohms)
Description:
In low impedance setup the speaker is connected directly to a low-impedance amplifier
(typically rated at 4Ω, 8Ω, or 16Ω). This method is commonly used in small to medium-sized
rooms where the amplifier is near the speakers, such as meeting rooms, boardrooms, or
home studios.
Note: In low impedance mode the AW-6P has an impedance of 8Ω.
Key Features:
• Higher sound quality due to full-range signal.
• Limited cable runs (usually less than 20 meters).
• One amplifier channel per speaker or a pair of speakers.
Bekijk gratis de handleiding van Kramer AW-6P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kramer |
| Model | AW-6P |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 2686 MB |
