Handleiding
Je bekijkt pagina 19 van 64
19
Step 4: Connecting the Refrigerant Pipe
1. Based on the wall hole position, select the appropriate piping mode. There are
three optional piping modes for indoor units, as shown in the figure below. In Piping
Mode 1 or Piping Mode 3, a notch should be made by using scissors to cut the
plastic sheet of the piping outlet and cable outlet on the corresponding side of the
indoor unit.
Note: When cutting off the plastic sheet at the outlet, ensure the cut is trimmed smoothly.
2. Bend the connecting pipes with the port facing up, as shown in the figure below.
3. Remove the plastic cover from the pipe ports and the protective cover from the
end of the piping connectors.
4. Check whether there is any debris on the port of the connecting pipe and ensure
the port is clean.
5. After aligning the centre, rotate the nut of the connecting pipe to tighten it as
much as possible by hand.
6. Use a torque wrench to tighten it according to the torque values in the torque
requirements table (refer to the torque requirements table in the installation
precautions section).
1
2
3
Piping outlet
Cable outlet
Yes
N
o
Bekijk gratis de handleiding van Kogan KASHSAC26TA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kogan |
| Model | KASHSAC26TA |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 5814 MB |
