Klark Teknik Vnet Interface Power Supply handleiding
Handleiding
Je bekijkt pagina 13 van 33
24 25Quick Start GuideVNET INTERFACE POWER SUPPLY
3. Using the two screws removed in 2, attach one mounting bracket loosely to the side of
the Accessory, with the ’ear’ towards the front, pointing outwards.
4. Repeat 2 and 3 for the other side. Now push the lid towards the back of the unit as far as it
will go then align the bracket ears with the front edge of the lid. Now tighten the screws.
5. Offer the Accessory with its mounting brackets up to the reverse side of the Mounting Panel,
and fix it in place using the two sets of screws, washers and nuts removed in 1.
Note that the holes at the rear ends of the brackets may be used as cable tie-off points
if desired.
Operation
The Power Supply has one indicator for each output. These will both illuminate when the unit
is operating correctly. If one of the indicators should fail to illuminate, this could mean that
the output has been shorted. Check that the connections are made properly at each end of
the jack lead, and that the cable has not become damaged.
Quick Start
• • Connect a jack lead to the accessory
• • Connect the mains supply
Bekijk gratis de handleiding van Klark Teknik Vnet Interface Power Supply, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Klark Teknik |
| Model | Vnet Interface Power Supply |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 3324 MB |