Klark Teknik Vnet Interface Power Supply handleiding
Handleiding
Je bekijkt pagina 12 van 33
22 23Quick Start GuideVNET INTERFACE POWER SUPPLY
Introduction / Key Features
This product is intended to provide DC power for arange of Klark Teknik VNET™ accessories.
Housed in a convenient, rugged steel case, it can be used free-standing or, using the
rack-mount kit, may be racked along with up to two companion accessory products,
all in just 1U of rack-space.
• • Can power one or two accessories
• • Rugged steel enclosure
• • Free-standing or rack-mount options
Connecting an Accessory
There are two DC outputs from this product, either of which may be used to power a
compatible accessory. By using both outputs, two accessories may be powered simultaneously.
No more than two accessories may be powered from one Power Supply.
Use one of the supplied 3.5 mm jack cables to connect one of the Outputs to the EXT DC jack of
the accessory, as shown in diagram 1:
Or connect two accessories using two jack cables as shown in diagram 2:
WARNING: Please refer to the information on the exterior of bottom enclosure for electrical and
safety information before installing or operating the device.
EXIT
50
100 - 240 V ~ 50 / 60 Hz 30W
OUT B
NOTE
only connect approved equipment
OUT A
Power supply
Jack cables
Accessory
EXIT
50
100 - 240 V ~ 50 / 60 Hz 30W
OUT B
NOTE
only connect approved equipment
OUT A
Power supply
Jack cables
Accessory
EXIT
Accessory
Racking
The VNET™ Interface and Accessory Power Supply may be used free-standing. If you wish to
mount them in a 19-inch rack, then the Accessory Mounting Kit may be used. To mount an
Accessory in the Mounting Kit panel:
1. Remove the two mounting brackets and Lexan blanking sheet which are covering the
aperture you wish to mount the Accessory in, by removing the two nuts.
(Keep these and the screws and washers).
2. Remove the two screws from one side of the Accessory.
Bekijk gratis de handleiding van Klark Teknik Vnet Interface Power Supply, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Klark Teknik |
| Model | Vnet Interface Power Supply |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 3324 MB |