Kichler Pillar handleiding
Handleiding
Je bekijkt pagina 6 van 60
6 | KICHLER.COM
HANGING THE FAN
REMEMBERREMEMBER to turn off the power before you begin installation. This is
necessary for your safety and also the proper programming of the control
system. To properly install your ceiling fan, follow the steps below.
Step 1.Step 1. Before attaching fan to outlet box (not included), ensure the outlet box
is securely fastened to at least two points to a structural ceiling member
(a loose box will cause the fan to wobble). Pass the 120 volt supply wires from
the ceiling outlet box through the center of the ceiling mounting bracket.
Install mounting bracket to outlet box in ceiling using the screws and washers
included with the outlet box. (Fig. 5)
Step 2. Step 2. Remove the hairpin and clevis pin from the downrod assembly,
retain for later use. Remove the hanger ball from the downrod assembly by
loosening set screw, removing the cross pin, and sliding ball o the rod.(Fig.6)
Note:Note: Make sure to keep loosen hardware separate to avoid confusion during
installation.
Step 3.Step 3. Loosen the two set screws on the motor coupling.(Fig. 7)
Outlet box
Ceiling Mounting Bracket
Flat Washer
Set Screw
Set Screw
Hanger Ball
Cross Pin
Clevis Pin
Hair pin
Screw
Fig. 5
Fig. 7
Fig. 6
Bekijk gratis de handleiding van Kichler Pillar, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kichler |
| Model | Pillar |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 4807 MB |
