Kichler Fit handleiding
Handleiding
Je bekijkt pagina 9 van 84
54" Fit | 9
Step 4. Carefully feed fan wires and safety cable up through the downrod.
Thread the downrod into the motor coupling until the hitch pin holes are
aligned. Next, replace the hitch pin and retaining clip.
NOTE: Be careful not to jam the hitch pin against the wiring inside of
the downrod. Tighten both set screws. (Fig. 8)
Step 5. Slip the coupling cover, canopy trim ring (smooth finished side
facing motor body), and canopy onto the downrod. Carefully reinstall
the hanger ball onto the downrod. Carefully reinstall the cross pin
through the hanger ball and downrod.
NOTE: Be careful not to jam the cross pin against the wiring inside
of the downrod. Make sure the cross pin is in the correct position.
Tighten the cross pin. Tighten the set screw on the hanger ball.
Make sure the wires are not twisted. (Fig. 9)
Step 6. Lift the motor body into position and place the hanger ball into
the mounting bracket. Rotate the entire assembly until the “Check Tab”
has dropped into the “Registration Slot” and seats firmly. (Fig.10) The
entire motor body should not rotate if this is done correctly.
WARNING: Failure to reattach the cross pin and seat the “Check Tab” can
cause the fan to fall from the ceiling during operation. Take special care to
make sure this pin is reattached.
HANGING THE FAN (continued)
Retaining Clip
Set Screw
Motor Coupling
Downrod
Hitch Pin
Set Screw
Hitch Pin
Retaining Clip
Fig. 8
Fig. 9
Motor Body
Hanger Ball
Canopy
Canopy
Trim Ring
Coupling Cover
Hanger Ball
Set Screw
Cross Pin
Check Tab
Mounting Bracket
Registration Slot
Hanger Ball
Fig. 10
Bekijk gratis de handleiding van Kichler Fit, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kichler |
| Model | Fit |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 6373 MB |
