Kichler Basics Pro Select handleiding
Handleiding
Je bekijkt pagina 13 van 60
ATTACHING THE FAN BLADES
CAUTION: Remove the rubber shipping blocks attached to the face of the motor. These
blocks keep the motor from shifting during shipping and MUST be removed during
installation.
Step 1. Attach the blade to the blade bracket using the screws and washers as shown in
Figure 14. Start screw into bracket. Repeat for the two remaining screws.
Step 2. Make sure the blade is straight and tighten each screw.
Step 3. Fasten blade assembly to motor using “Pre-Installed” mounting screws in the
blade bracket.
INSTALLING THE LIGHT KIT TO
SWITCH HOUSING
Step 1. Remove and discard the center plug from the switch housing.
Step 2. Attach the light kit to the switch housing by feeding the light kit wires (black and
white) through the hole of the switch housing and then screw it onto the switch housing
cover by nut & lock washer.
Step 3. Be sure it is tight enough to prevent light kit from vibrating loose (Fig. 15).
Step 4. Wire connect: White wire to white wire. Black wire to black wire.
Fig. 14
Screws
Washers
Screws
Blade brackets
Fig. 15
Switch
housing
52" BASICS PRO SELECT | 13
Blades
Light kit
Lock washer
Nut
Black
White
White
Black
Center
plug
Bekijk gratis de handleiding van Kichler Basics Pro Select, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kichler |
| Model | Basics Pro Select |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 4727 MB |
